Reddit reviews 12V 10A Camera Power Supply with 8 Way Splitter Cable, AC 100-240V to DC 12V 10Amp Power Adapter, 1 Female to 8 Male Connectors for CCTV Security System / LED Strip Lights
We found 6 Reddit comments about 12V 10A Camera Power Supply with 8 Way Splitter Cable, AC 100-240V to DC 12V 10Amp Power Adapter, 1 Female to 8 Male Connectors for CCTV Security System / LED Strip Lights. Here are the top ones, ranked by their Reddit score.
Regulated switching power supply with 1 to 8 power adapter cableAC Input: 100V to 240V DC Output: 12 Volt at 10 AmpProtections: Short circuit, Overload, Over voltage, Over temperatureFor the Led Strip/Wireless Router, ADSL Cats, HUB, Switches, Security Cameras, Audio/Video Power SupplyNote: This power supply power is 120W, can ONLY use on the device which power is lower than 120W. If you received the products and plug in no voltage on it, please plug off and plug into again, please make sure you have pluged it tightly. And if it still can not work, just contact us, we will provide the best service to you. Please don't worry about it, any problem we will try our best to help you.
I've got 3 or 4 of the Winkeyes AC 100-240V to DC 12V 10A Switching Power Supply Adapter from Amazon
that I use with my MP Mini Delta's and Select Mini's V1/V2
There is no harm in using a higher amperage power supply. The printer will only take what it needs.
Hi there,
I'm wondering how many of you have successfully resolved your heating issues on the MPMD. I've upgraded the power supply to this (https://www.amazon.com/gp/product/B018G3ABWY/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1), and it's certainly made the bed heat a little more quickly. However, I'm still seeing a lot of fluctuation from the bed and the hot end. I don't care about the bed too much, but +-10 degrees constantly on the hot end is... not ideal.
I've got the v43 firmware (got this as a graduation gift, and that was the firmware it came with)...
What am I missing?
Amazon sells a PSU that works without any modification: https://www.amazon.com/dp/B018G3ABWY/ref=cm_sw_su_dp
Is there a way to test if the thermistor is shorting or any resources you'd recommend checking out?
My printer will randomly shut off, during some prints and go completely black. Then I'll have to replug the power adapter and flip the switch on and off a couple times to get it to boot back up.
I already got a replacement power supply recommended by the wiki (https://amzn.com/B018G3ABWY ) because I thought that was the issue at first, but no luck since it happens with that supply in, too.
What's weird is that I was able to complete one print with the original power supply, and I came back well after it had finished, and the machine was still on and everything.
Then, it started crapping out again. I even took off the side panel by the sd card slot and aimed a small fan at the board to give it some cooling in case the card was overheating (even though this isn't a modded machine), but that died mid-print, too.
I checked the board and didn't see and obvious shorts, so I'm thinking maybe it's the bed.
Tl;dr - Tried a lot of stuff, and I think it's the thermistor. Any way to check or recommended guides?
https://amzn.com/B018G3ABWY
20$ plug and play, works great
I've got this one on order and it should arrive tomorrow. Found it from the wiki page.