Reddit reviews 3M 2155 Rubber Splice Tape
We found 8 Reddit comments about 3M 2155 Rubber Splice Tape. Here are the top ones, ranked by their Reddit score.
Package length: 9.652 cmPackage width: 9.652 cmPackage height: 2.032 cmProduct Type: WALL ART
Caulk is not a good solution for this. Use self-amalgamating tape like 3M TemFlex. You stretch it and wrap it around the pipe and the joint, and it bonds to itself and turns into a waterproof shield similar to heat shrink tubing. You have to cut it away to remove it, but it has no adhesive so it won't leave a mess. I use this to protect antenna and RF cable connections, it lasts forever and completely protects from water and weather.
https://www.amazon.com/3M-2155-Rubber-Splicing-Tape/dp/B001CGVEXS/ref=sr_1_4?ie=UTF8&qid=1480268004&sr=8-4&keywords=self+amalgamating+tape
I would take the driver assembly off of the frame (aka remove the thand use an epoxy specially formulated to bond plastic to glue the pieces together. I recommend JB PlasticWeld. You probably want to practice on something else before you try it on your cans, since it dries super quick and you only have one shot at this.
One that has fully cured (it says 1hr but definitely give it a full 24hours), I would wrap the cracked part of the frame tightly in a self-sealing tape. This is a rubber tape which resembles electrical tape but it has no 'adhesives'. What you do is stretch it out as you wrap it and then tightly overlay half of the width over your last pass each time. It will fuse to itself and should support it pretty well. Make sure you have enough clearance to put the layer of tape on and still reattach the driver assembly back on, because once it's one there it's not going to come off without a huge fight (which is the whole point). Again, practice beforehand on something else. I personally use the 3M brand all the time with good results, and it's super cheap. Link.
Good luck.
This is what I use for wrapping ice tools, if you want a cheap fix.
http://www.amazon.com/3M-2155-Rubber-Splicing-Tape/dp/B001CGVEXS
Some people use PlastiDip which is more durable but not as grippy.
I haven't bothered with either on my mountaineering axe because I mostly hold it by the pick anyway.
Here is the mobile version of your link
I'm just looking on Amazon, I see 3M Rubber Splicing Tape as Temflex 2155.
3M Rubber Splicing Tape https://www.amazon.com/dp/B001CGVEXS
Maybe Temflex 1300 is more traditional (sticky) electrical tape.
Try rubber splicing tape. It'll stick to itself but not anything else. Makes for good handle grips and it's easy to clean if it gets dirty. Just rinse it off and it's all good.
If you like the look and the properties of this stuff, you can get an almost identical product from your local hardware store. I'm really happy with the durability of mine and that single cheap roll can do a couple bikes