Reddit Reddit reviews Bostitch BTFP72326 Regulator and Gauge Kit with 1/4-Inch NPT Thread

We found 3 Reddit comments about Bostitch BTFP72326 Regulator and Gauge Kit with 1/4-Inch NPT Thread. Here are the top ones, ranked by their Reddit score.

Industrial & Scientific
Filtration
Compressed Air Filtration
Compressed Air Filters, Regulators & Lubricators
Compressed Air Combination Filter Regulator Lubricators
Bostitch BTFP72326 Regulator and Gauge Kit with 1/4-Inch NPT Thread
Country of Origin:ChinaPackage length:6.7"Package width:4.5"Package height:2.0"
Check price on Amazon

3 Reddit comments about Bostitch BTFP72326 Regulator and Gauge Kit with 1/4-Inch NPT Thread:

u/csmicfool · 2 pointsr/PlantedTank

I'll go in order from the CO2 tank down the line:

  • 10lb Aluminum tank, bought at local welding/gas supply

  • This 2-stage CO2 Regulator

  • Replaced the output fitting with one of these

  • Then I have a smaller regulator reduce the line pressure down to a stable 15 psi - I find that the more regs, the better for stable pressure.

  • That leads to two solenoids, one for each tank. You can buy the cheapish milwakee one, or anything that uses 1/4" npt fittings if you can find a better deal.

  • After each solenoid I have a T-junction to a gas pressure sensor reading back to my controller, and the other outlet to the final regulator. You can use the one above, or one of these

  • No need for a needle valve at this point. Go to your bubble counter and then up to your tank.

  • On my big tank I am using a reactor instead of the normal ceramic diffuser I have on the small one.
u/ARAR1 · 1 pointr/engineering

You need a pressure regulator. https://www.amazon.com/Bostitch-BTFP72326-Regulator-4-Inch-Thread/dp/B00HXD2V36/ref=mp_s_a_1_7?keywords=pressure+regulator&qid=1572565174&sr=8-7

Pressure is related to flow. So what happens to the gas in the tube is what will determine the actual pressure.

u/nevets01 · 1 pointr/Nerf

like this one?