Reddit Reddit reviews Candy Tin Ouija Mystifying Mints 1.5 oz

We found 4 Reddit comments about Candy Tin Ouija Mystifying Mints 1.5 oz. Here are the top ones, ranked by their Reddit score.

Grocery & Gourmet Food
Candy & Chocolate
Candy Mints
Candy Tin Ouija Mystifying Mints 1.5 oz
Includes: one 1.5oz ouija mystifying mints candy tinDimensions: approximately 3.75 inch x 2.5 inch x 0.75 inchCandy made in usaTin made in china
Check price on Amazon

4 Reddit comments about Candy Tin Ouija Mystifying Mints 1.5 oz:

u/DaveX64 · 6 pointsr/electronics
u/Nparallelopposite · 3 pointsr/mildlyinteresting




Found the Amazon link for you
Https://www.amazon.com/Candy-Tin-Ouija-Mystifying-Mints/dp/B005VG89QU

u/HoneyWizard · 2 pointsr/cassetteculture

Yep! Pretty straightforward mod. You desolder the trim pot, then solder three wires to the pads where the trim pot was. After that, solder the other end of the three wires to your potentiometer and you're done as far as the sound's concerned. For usefulness/cosmetcs, I cut a hole in my Walkman case to run the wires out, then poked a hole in the side of an Altoids tin, sanded away the rough edges, and threaded the other end of the wires through. Then I drilled a hole in the top of the Altoids tin big enough to get the potentiometer shaft to fit through and spin freely while still being snug. When I was sure of that, that's when I soldered the wires to the pot. Then I hot-glued the pot into the backside of the tin's top lid (it's too small to glue to the tin bottom), being careful not to cover any wires or pads, closed the lid, put down the numbered dial position circle thing (with some gorilla glue to make sure it'd stay in place), and finally put the potentiometer's knob on. Here's the exact pot I used and the Ouija Altoids tin.

The reason I don't trust my handiwork is I didn't have a Dremel for the Walkman case hole, and had to use wire-cutters to snip off bits instead. I sanded it down a little, but I could've done a better job. I'm worried it'll cut the wires over time. The wires themselves are also pretty long (about 18") and prone to tangling. The length is enough that I can keep the Walkman on a belt-clip while holding the Altoids tin at waist-height, but I mostly use it on my desk, so it's pointless. If I make another, I'll halve the length and add a few bands to keep the wires straight and tangle-free.