Reddit Reddit reviews GodHand GN-125 Plastic Cutting Nipper

We found 1 Reddit comments about GodHand GN-125 Plastic Cutting Nipper. Here are the top ones, ranked by their Reddit score.

Tools & Home Improvement
Hand Tools
Nippers & Snips
Power & Hand Tools
GodHand GN-125 Plastic Cutting Nipper
Cutting capacity: 3mm or less[Pula rod 3mm]
Check price on Amazon

1 Reddit comment about GodHand GN-125 Plastic Cutting Nipper:

u/Ghost_of_Akina ยท 1 pointr/Gunpla

For the white marks there are two things to help.

  1. Make two cuts with your nippers - one about halfway down the gate (the plastic between the round parts of the runner and the actual part) to free it from the runner, then a second cut with the nippers flush against the part. I've been doing this recently and while you have to make more cuts, the amount of cleanup you have to do is minmal to none. I started doing this halfway through my MG Jesta because that black plastic was nub mark city and the results were night and day. HOWEVER, if you have crap nippers then you may run into the same problem soooooo.....

  2. BUY GOOD TOOLS! You don't need to go out and buy the fabled SPN-120 nippers, but I would seriously recommend these: GodHand GN125. They are far and away the best nippers I have used for the price. They cut nicely, hold their edge well, and on the lighter color plastics I can get cuts that need no cleanup at all with them. Much better than the ones you'll get at the local hobby lobby! For X-actos I've started using their Z-series blades and they too have made my gunpla a lot better looking than whatever old ones I was using before I went tool shopping. Having the right tools makes a HUGE difference, enough to justify the expense if you're building more than 1-2 kits.