Reddit Reddit reviews ISC Racerstape Surface Protection Tape / Helicopter Tape 2 Inch x 12 Feet

We found 13 Reddit comments about ISC Racerstape Surface Protection Tape / Helicopter Tape 2 Inch x 12 Feet. Here are the top ones, ranked by their Reddit score.

Paint, Wall Treatments & Supplies
Masking Tape
Tools & Home Improvement
Household Painting Supplies & Tools
Paint Supplies Tape
ISC Racerstape Surface Protection Tape / Helicopter Tape 2 Inch x 12 Feet
Clear protective urethane film is virtually invisible to the naked eyeProtects any surface that is prone to scratching, chipping, and weatheringAlso protects against UV-light, temperature extremes and solventsWill not yellow over timeFeatures a semi-permanent adhesive, with a removable release liner
Check price on Amazon

13 Reddit comments about ISC Racerstape Surface Protection Tape / Helicopter Tape 2 Inch x 12 Feet:

u/hunter006 · 6 pointsr/bikepacking

Amazon, most hardware or automotive stores would have some variant. It goes by a bunch of different names. This is one example:

https://www.amazon.com/gp/product/B000TPC7HU/

u/kangsterizer · 2 pointsr/bikepacking

Or https://www.amazon.com/gp/product/B000TPC7HU if you don't like black ;-)

I'd also recommend taping the entire bike with it anyway because paint chips even more quickly when you bikepack haha. (Or at least, the down tube and the chainstays in addition to where the bags touch the frame)

u/dwcanker · 2 pointsr/MTB

Just finished taping up my new bike about 2 hours ago.
https://www.amazon.com/gp/product/B000TPC7HU/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1
Used that stuff. Never really bothered before other than the chain stay to protect it from chain slap but new bike is carbon and pricey. It went on easy using the soapy water method. Only real issue I have is it is glossy and the frame is matte so it is fairly obvious. I also used some 3m 2228 mastic tape in areas it would be a pita to use the other stuff and more likely to take heavy hits.

u/lk05321 · 2 pointsr/bikecommuting

FYI helicopter tape is pretty useful for covering up areas where paint can chip from rocks, debris, and chain-slap. It’s the same stuff used to protect phone screens from wear and tear, and apparently helicopter blades. This roll is way cheaper than the made-for stuff.

u/ppardee · 2 pointsr/cycling

You can get clear 'helicopter' tape from Amazon for a reasonable price to replace that, and maybe add some to the underside of your downtube, too, if it doesn't already have it.
As an example (I've never used this - I'm not specifically recommending this brand):
https://www.amazon.com/ISC-Racers-Tape-HT2128-Transparent/dp/B000TPC7HU?ref_=fsclp_pl_dp_3

u/jeffwhat · 2 pointsr/Wellworn

you can use helicopter tape/racers tape to prevent that.

u/spleeble · 1 pointr/FixedGearBicycle

This is the exact thing I got.

Kind of pricey but it seems like the roll will last for every bike I ever own.

u/philtech · 1 pointr/bicycling

I use ISC Racers Tape.
https://smile.amazon.com/dp/B000TPC7HU/ref=cm_sw_r_cp_apa_i_595SCbRDHK3ZP

Not just water, but slightly soapy water. It breaks the surface tension on the water allowing it to completely cover the adhesive so you can easily position it on the frame. Lots of soapy water. You can't use too much. Be careful not to get water on the backing paper before peeling off the tape. It has a tendency to pull apart and stick to the tape if you get it wet. If your hands are wet with soapy water you can handle the adhesive side without leaving fingerprints. I use a dish towel to squeegee and dry around the edges. It won't start to stick well until it squeegees out and dries. If it slips when your squeegeeing splash more soapy water on it and have another go at it.

I just wrapped a new steel hardtail in 1", 2", and 4" tape because it's gonna take a thrashing.

u/m85476585 · 1 pointr/GooglePixel

I'm using this tape to cover the back for now, and it is a lot grippier than the bare aluminum, the back glass, or even my plastic screen protector. If they use a similar material it should have some grip. "Self-Healing, flexible, tough, military-grade thermoplastic urethane, designed to absorb impact" sounds grippy. Good point about peeling. Maybe clear adhesive film for the back plus a bumper case would be a good combo.

I have Thule Atmos X3 case on my old phone, and it's awesome. It's thin and unobtrusive (adds maybe 2-3mm thickness), but it protected that phone every time I dropped it. It's made of high quality co-molded materials with a subtle design and variety of textures. Too bad they seem to have given up on Android phones.

u/whatremix · 1 pointr/cycling

It's a little pricey, but I've heard good things about helicopter tape:
LINK

u/firstroadbike · 1 pointr/bicycling

I just got a new bike and felt the same way for a while. After some research I found this: ISC Racers Tape/Helicopter Tape. A number of people online seem to like it.

After getting used to the fact that I will probably bang up my bike a good bit more and I might as well get over it, I decided to buy a little anyway. I'm going to put it on a few spots I worry about i.e. to prevent chainslap and where the bike touches my bike rack. Might as well make a small effort to help the resale value if I ever want to sell it.

u/winkers · 1 pointr/MTB

While this can't fix the existing scratches, if you are serious about protecting your frame then consider applying some helicopter/racer tape to the most vulnerable areas.

It's basically a thick version of protective films they use on electronic screens. UV stable and can take a beating. Bonus is that it peels off without hassle or marks. A lot of the guys in my area use it to protect their carbon frames. Just clean the application area well with alcohol before putting the tape on.

http://www.amazon.com/ISC-Racerstape-com-Paint-surface-guard/dp/B000TPC7HU