Reddit reviews Landgarden Outdoor Misting Cooling System,33ft Misting Line,11 Brass Mist Nozzles for Patio Garden Greenhouse
We found 2 Reddit comments about Landgarden Outdoor Misting Cooling System,33ft Misting Line,11 Brass Mist Nozzles for Patio Garden Greenhouse. Here are the top ones, ranked by their Reddit score.
【Upgrade Quality】: Updated mist system nozzle are made of precision brass, Easy connect,leak-proof and self-sealing Tee Joint ,high quality UV treated flexible tubing, resistant to yellowing hydrolysis and microbial degradation,and meanwhile UV up to 3.5 or more.【Wide Application】: Misting Cooling System widely apply for garden, landscaping, greenhouse, humidification, outdoor cooling system, deodorant air purification, swimming pool misting fog cooling, mist mosquito system and so on【Easy to DIY install】: Providing you all the accessories you need for a air cooling and plant misting system,only need 10 minutes to Installs as your idea, delivers very fine mist to significantly cool the air in the hottest summer weather【Saving Energy and Water】: Misting cooling system directly use tap water to spray and cool down, no electricity consumption.Compare with manual watering on irrigation you can save 70% of water.Comparing with air humidification machine it works faster and more efficient【Creating a Natural Cooling Area 】: The fantastic outdoor cooling system provides a natural water cooling area,release you from the indoor bad air conditions and enjoy the fantastic outdoor sight in hot summer, surrounding air temperatures up to 20 degrees.
I put a Y on the hose spigot with individual isolation valves for each of the two parts. Garden hose is attached to one, misters are attached to the second.
Basically, yes, it’s permanently attached, but I ran it directly up from the wall in a corner so it’s as out of the way & discrete as I could’ve done it.
Link is below, it’s not the nicest mister system, aesthetically at least, but it works awesome & for the price it makes a huge difference.
https://www.amazon.com/dp/B07FC8BL7C/ref=cm_sw_r_cp_api_i_2PonDbQK9B8EG
This is what I did:
1. misting system
2. timer
3. water filter
And if you need it:
4. hose Y connector
I connected the Y connecter to the spigot, connected the timer to that and the water filter to the timer, misting system to the water filter. Spigot->timer->filter->misting system. The trickiest part is setting up the misting heads because they just give you a long length of piping and you have to cut it down and place the misting heads according to your needs. In the pack there are about eleven (don’t remember exactly) misting heads (they look like black plastic T’s) and one piece that looks like a misting spigot that’s actually a three way connector (the other ten are just two way connectors with the third being the misting outlet that you screw the brass misting head into). There’s also only one end cap plug that fits into the connecter hole for one of the misting heads to finish/cap off the line when you get to the end). Because I incorporated the 3 way connecter to have two layers of lines running parallel to each other, I just capped off the end of one of the lines with the end cap plug and the other with hot glue. A little janky but effective! So far, the misting system has been doing a much better job of watering the orchids than I ever was doing it manually. After you set it up you should do a trial run to see if all the heads are misting properly and if the timer works correctly. If you’re having issues with the misting heads not misting, try unscrewing them a little to see if loosening it helps. If not, I think they give you one extra brass misting head so swap it out for the spare and see if that helps. Good luck!