Reddit reviews LE Power Adapter, 5A, 100V-240V AC to 12V DC Transformer, 60W Power Supply, US Plug Power Converter for LED Strip Light and More
We found 7 Reddit comments about LE Power Adapter, 5A, 100V-240V AC to 12V DC Transformer, 60W Power Supply, US Plug Power Converter for LED Strip Light and More. Here are the top ones, ranked by their Reddit score.
I've been using multiple FLS-PP along with LED strips and it works fine with the current HUE firmware, you can get one of the modules and see if it works with your LED strip, just a quick look, and it has the same plug that the 5050s LEDs I have, but the 5050s LEDS are RGB.
or
How long of a strip? If it's 5 meters then you'll likely need a 12 volt 5 or 6 amp power supply.
http://www.amazon.com/Power-Adaptor-Transformers-Supply-Lights/dp/B00K71VMCW
edit- one plant, one pot. It's a common beginner's mistake to put multiple plants in a single pot. This is 3 inches of soil in a Tupperware container with the plant taken out of the container for photo purposes to give you an idea of what's possible.
http://imgur.com/wFhNaEb
Nunie,
This will actually work. remove Q1, Q2, Q3 and everything to the right and replace with this setup. For the transistors use this. Power the whole unit with something like this.
Let me know if you need more help. Cheers!
Greetings, Buckteers! I just installed my new 7020 LED strip powered by this adapter, and connected via this power jack adapter onto a bucket spacer and noticed only half of the LED is lit.
The other end of the strip does have wires soldered on, but I am not using them. My understanding of LED strips is that I could connect another adapter to those wires and I would not experience dimming due to voltage drop on that end. Does anyone have experience with this phenomenon? I have not contacted the seller yet. Thanks, y’all!!
I believe I used these two:
https://www.amazon.com/gp/product/B00K71VMCW/
https://www.amazon.com/gp/product/B00MHKCTLE/
I haven't purchased the LED's yet. I was looking at getting the two below and then splicing the power cord from the LEDs into the toggle switch/grounding wires.
LEDs
transformer
That way everything is grounded except for the light socket and hooked into the toggle switch. What do you think?
No problem.
I was also looking at an alternative solution from another reddit post which would use the following items:
If this makes sense then it would look something like this?
LED strip --> strip connector --> 10m extension cable (through ceiling) --> strip connector --> LED strip for cabinets on other side of wall
Found a very informative video of the ballast + LED strips + hue bridge: https://www.youtube.com/watch?v=VNfa9X5Sq1Q
That's already $93 + tax so if it makes more sense to just get a refurb hue strip kits and synchronize them to the same room (Kitchen) then I guess I will go with another set of hue strip kits.