Reddit reviews LEDwholesalers Aluminum Channel System with Cover, End Caps, and Mounting Clips, for LED Strip Installations, V-Shape, Pack of 5x 1m Segments, 1901-V
We found 3 Reddit comments about LEDwholesalers Aluminum Channel System with Cover, End Caps, and Mounting Clips, for LED Strip Installations, V-Shape, Pack of 5x 1m Segments, 1901-V. Here are the top ones, ranked by their Reddit score.
Pack of five (5) 1m segments, including end caps and mounting clipsExtruded aluminum channel with translucent coverV-shaped for angled lightingProfessional mounting solution for installing LED strips/ribbonsProtects delicate LED strips/ribbons from dust and physical contact
If you don't mind going the DIY route, you could probably come in under $100 for parts for the strips:
Instead of the flat channel, you might be better off with angled channel for mounting the strips above the cabinets, since they'll throw more light on the wall, which is what you'll actually see - https://www.amazon.com/LEDwholesalers-Aluminum-Mounting-Installations-1901-V/dp/B00PJSSD7K/
There's a ZWave RGBW controller but it's more expensive than the wifi one and can take some more configuration: https://www.amazon.com/Fibaro-Micro-Controller-Z-wave-Strips/dp/B00P1N68FW/
If you get the snap-on connectors, I recommend putting a small amount of solder on all of the pads where you'll be connecting them on the strips, so that they make a good connection.
As for the puck lights, you could probably get something like this and wire the distributor to the wifi/ZWave controller, instead of plugging it into the controller it comes with: https://www.amazon.com/Changing-Christmas-Furniture-Ambiance-Lighting/dp/B01N2I47VH/ref=sr_1_2
I'm just gonna have to start recommend this to everyone with LEDs lining their ceiling. LED TRACK WITH DIFFUSER
It improves the look by 4000% at least, and is much easier on the eyes than bare diodes.
These(or similar) with this over it! Make it flush with the ceiling on one side or all sides of the room. You could also get a flat version of that to put along floorboards in hallways, and all you'd need to keep it up is some small screws. That's all I can do to help!
Either that of you could just find some paper lantern covers for your lights and put them on each bulb.