Reddit Reddit reviews Lisle 35260 Plastic Fastener Remover

We found 11 Reddit comments about Lisle 35260 Plastic Fastener Remover. Here are the top ones, ranked by their Reddit score.

Body Repair Upholstery & Trim Tools
Body Repair Tools
Automotive Tools & Equipment
Automotive
Lisle 35260 Plastic Fastener Remover
Removes Plastic Hold-Down Fasteners.This tool quickly removes various types of plastic fasteners that hold on weather stripping, radiator shrouds, fender linings, air dams and other plastic or rubber partsThe tool is equipped with a sliding urethane button for use when extra leverage is necessary
Check price on Amazon

11 Reddit comments about Lisle 35260 Plastic Fastener Remover:

u/RIKENAID · 13 pointsr/Justrolledintotheshop

From one Subaru owner to another. Hope this helps.

Lisle 35260 Plastic Fastener Remover https://www.amazon.com/dp/B0002SRCMO/ref=cm_sw_r_other_apa_6WpMyb4EWP6PR

Clipsandfasteners Inc 15 Subaru Bumper Engine Cover Fender And Grille Clips https://www.amazon.com/dp/B00588T81Q/ref=cm_sw_r_other_apa_IYpMybKHCF30R

u/leakytransmission · 3 pointsr/MechanicAdvice

Shouldn't be too hard. Be sure to acquire new fasteners for the door panel before you take it apart and get yourself a panel tool like this to make it easier on yourself: http://www.amazon.com/Lisle-35260-Plastic-Fastener-Remover/dp/B0002SRCMO/

When taking the panel off the door take your time and make sure you disconnect wiring harness in there as you go so you don't accidentally overextend any of them. Once that's off it is usually a couple nuts/screws to remove the mirror. Then install the new one by putting the nuts/screws back on. Put new door panel fasteners on your door panel. Connect wires back up and press it back on. Be careful around the door locks if you have the pin type that pops up and down as the linkage can become bent; on some cars you can remove the pin by unscrewing it before you start but for other styles you can't remove it because it's square.

u/Potbrowniebender · 2 pointsr/ToyotaTacoma


This has always helped me out.

Lisle 35260 Plastic Fastener Remover

https://www.amazon.com/dp/B0002SRCMO/ref=cm_sw_r_sms_awd_RlSQwbH88JRR5

u/OhioJeeper · 2 pointsr/cars
u/hobbestigertx · 2 pointsr/Chevy

The key to pulling the door panel is to use the right tool.

You just slide it under the panel and slide it left or right to find the fastener. Then use it as a lever to pop the fastener loose. Works like a charm.

You can find it at any auto parts store for less than $10. A million uses beyond pulling door panels too.

u/HardcorePooka · 2 pointsr/Cartalk

From what I can see you're going to want to get a tool like this https://www.amazon.com/Lisle-Drake-Off-Road-Tools/dp/B0002SRCMO/ref=sr_1_1?ie=UTF8&qid=1518368702&sr=8-1&keywords=clip+tool

at least if you plan on doing this a lot. Otherwise, a flat had screwdriver should be able to pry up the center section and then pull them out.

u/[deleted] · 1 pointr/CherokeeXJ

They're really easy, just look up how your door panel comes apart so you don't have to pull on things and guess.


Buy this tool, or one like it. It makes the job really easy:


https://www.amazon.com/Lisle-35260-Plastic-Fastener-Remover/dp/B0002SRCMO/ref=sr_1_41?keywords=door+panel+clip+tool&qid=1556081230&s=gateway&sr=8-41

u/Pilot1226 · 1 pointr/subaru

I bought a Lisle tool that helps a ton with lifting them.

https://www.amazon.com/Lisle-35260-Plastic-Fastener-Remover/dp/B0002SRCMO

It's glorious. I have used it a bunch of times now on several cars.

u/getzall · 1 pointr/mercedes

You should be able to pop the panel off with a panel popper tool. Car stereo shops do it all the time.

u/chillywilly69 · 1 pointr/MachinePorn

found it. thank you!