Reddit Reddit reviews M7 x 0.5 Metric HSS Right Hand Tap with 6.5mm Drill Bit

We found 4 Reddit comments about M7 x 0.5 Metric HSS Right Hand Tap with 6.5mm Drill Bit. Here are the top ones, ranked by their Reddit score.

Industrial & Scientific
Threading Taps
Cutting Tools
M7 x 0.5 Metric HSS Right Hand Tap with 6.5mm Drill Bit
M7 x 0.5 HSS right hand thread tap with 6.5mm HSS drill bit
Check price on Amazon

4 Reddit comments about M7 x 0.5 Metric HSS Right Hand Tap with 6.5mm Drill Bit:

u/xakh · 3 pointsr/3Dprinting

Ooznest is great, they actually used to sell an i3 kit that was quite good, and my goto for Great Britain recommendations insofar as cheap-ish kits were concerned. Last I checked they're a genuine reseller, so what you got should be the correct component. Anyway, if you want to upload a picture, the easiest way is to upload it to an external image host, like imgur, for instance, then link it in your comment.

So, by broken in half, do you mean it looks like this? If so, it is possible to overtorque the two halves against each other inside an M6 nut. It'll be pretty wobbly, and it definitely won't last for more than a couple of prints, but it should work enough to get it through a single print. Actually, since you ordered from Ooznest, you're probably in the UK, or nearby in Europe, right? That means hardware stores should just carry most kinds of metric fasteners, and you can get ahold of an M6 coupler nut, which would definitely join the two halves together long enough for you to get a print off of it. In addition, you could get an M7 tap of some sort, and drill out the Anet's original heatsink. The E3Dv6's heatbreak is an M7 on the top, M6 on the bottom, so that could work. You'd have issues with heat creep long-term, since the E3D uses a metal interior instead of PTFE like the Anet does, but you'd probably be able to get the mounting adapter for an E3D off of it before it gunked up too much.

u/cyburai · 1 pointr/electronic_cigarette

> M7x0.5 tap or thread follower

Like this? http://www.amazon.com/Metric-Right-Thread-0-5mm-Pitch/dp/B00C88E0IA

u/IrLoserBoy · 1 pointr/electronic_cigarette

At the top of this thread someone said these measurements and this is what I found 7mm X .5 Metric HSS Right Hand Thread Tap M7 X 0.5mm Pitch
http://www.amazon.com/dp/B00C88E0IA/ref=cm_sw_r_an_am_ap_am_us?ie=UTF8