Reddit Reddit reviews MG Chemicals Total Ground Carbon Conductive Coating, 340 g (12 Oz) Aerosol Can, Dark Grey

We found 5 Reddit comments about MG Chemicals Total Ground Carbon Conductive Coating, 340 g (12 Oz) Aerosol Can, Dark Grey. Here are the top ones, ranked by their Reddit score.

Industrial & Scientific
Industrial Coatings
Tapes, Adhesives & Sealants
MG Chemicals Total Ground Carbon Conductive Coating, 340 g (12 Oz) Aerosol Can, Dark Grey
High Conductivity - Low Surface resistivity of 250 Ω/sq for one coat (1 mil)Tough and durable coating, salt spray tested with excellent weatherabilityRub off resistant - Stronger adhesion than water based coatingsCorrosion-proof coat - slows or prevents substrate oxidationRepairable and removable thermoplastic paint system
Check price on Amazon

5 Reddit comments about MG Chemicals Total Ground Carbon Conductive Coating, 340 g (12 Oz) Aerosol Can, Dark Grey:

u/nickythegreek · 6 pointsr/PrintedMinis

I've successfully used carbon conductive spray paint on resin prints to create a conductive surface to electroplate.

https://www.amazon.com/gp/product/B008OA931A

u/t0Fu1 · 2 pointsr/3Dprinting

I wouldn't bet on it. Conductive pla has a very high resistance so it would plate very well. What you can do as an alternative is take a part printed with any filament and give it a coat with this stuff
http://www.amazon.com/MG-Chemicals-Conductive-Coating-Aerosol/dp/B008OA931A then you can electroplate just fine.

u/abstractism · 1 pointr/Guitar

there's no shielding at all, but I don't know how to go about this. its a spray paint type stuff, shown here and the description/reviews say it sticks to plastics quite well so I'd have to mask off possibly all of the outside of the guitar, right?

u/willcode4beer · 1 pointr/motorcycles

There are several spay paints you can use that are conductive and they can be electroplated.

example: http://www.amazon.com/MG-Chemicals-Conductive-Coating-Aerosol/dp/B008OA931A/

A lot of the guys I know into 3D Printing, do it for finishes (usually copper or nickel plate but, chrome works the same).

After painting, use progressively finer sand paper to get a smooth finish (I'd recommend going to 1000 grit). You can even get an electroplating kits from amazon.

u/lps2 · 1 pointr/electroforming

I use a paint from ABR Imagery. I have found that the paint from Caswell separates too easily and is rougher than the ABR paint.

Caswell offers a paint that can be sprayed but it is very pricey.

I was also able to find this carbon conductive spray on Amazon