Reddit reviews Milescraft 1318 Drillmate Drill Guide with chuck
We found 8 Reddit comments about Milescraft 1318 Drillmate Drill Guide with chuck. Here are the top ones, ranked by their Reddit score.
Perfect for straight or angled drilling, drilling on the edge of a board or on round stockAttaches to all 3/8" And 1/2" Power drills and it also includes a 3/8" Capacity chuck with keyAngle cuts of 45 Degree to 90 degrees, with a built in angle read out in the all metal baseCentering channels built into the bottom of the base, to accommodate drilling any round stock up to 3 inches in diameterAdjustable depth stop and spring action control of the head
I don't know anything about dowels, but if the OP is talking about the need to drill perpendicular holes, I just picked up this jig and I like it so far for general woodworking:
Milescraft 1312 DrillBlock
​
There's another style that might be more precise for dowels since you can buy more bushing sizes. For example:
Dowel drill bit guide
​
And if you need more angles than just 90 degrees, there are hand drill guides like this one:
Milescraft 1318 Drillmade drill guide
​
Edit: I don't necessarily recommend the specific models in the 2nd and 3rd links. They were just the first examples I came across.
Something like this (https://www.amazon.ca/Milescraft-1318-DrillMate-Drill-Guide/dp/B014A1Z92I/ref=asc_df_B014A1Z92I/?tag=googlemobshop-20&linkCode=df0&hvadid=292949808887&hvpos=1o2&hvnetw=g&hvrand=6187848914128197040&hvpone=&hvptwo=&hvqmt=&hvdev=m&hvdvcmdl=&hvlocint=&hvlocphy=9000694&hvtargid=pla-437180793075&psc=1) would be cheaper but would drill straighter holes than free handing it
You could try one of these drill guides . It’s sort of like a portable drill dress. Will probably still be tricky with forstner or spade bits though.
I did it without a drill press - did it by hand without an aid actually, but I've been doing woodworking for a while so I'm pretty comfortable with that. I know you can get a drill that has a bubble level on the back, which is great if you have that. There are also drill guides like this one.
I haven’t tried one but [I’ve seen this](Milescraft 1318 Drillmate Drill Guide with chuck https://www.amazon.com/dp/B014A1Z92I/ref=cm_sw_r_cp_api_i_wS9JDbTKQYZ2Q) which could help.
Originally I was planning to drill them on the drill press before lamination the top. I totally forgot to do that, so I impatiently went at it with a forstner bit. I should have gotten a drill guide because some of the holes are a touch wonky.
https://www.amazon.com/Milescraft-1318-DrillMate-Drill-Guide/dp/B014A1Z92I
Also - I don't have a drill press, so I'm considering getting one of these drill-holder-guides from Milescraft or Wolfcraft in order to control the drill during this operation.
This is the one I used. I would be very cautious to use it again. Just be sure it is square before you start. I set mine at the labeled 90deg mark on the tool but clearly was not.