Reddit reviews Orbit 67000 8 Port Adj Flow Manifold
We found 3 Reddit comments about Orbit 67000 8 Port Adj Flow Manifold. Here are the top ones, ranked by their Reddit score.
Eight 1/4-Inch barbed ports with threads (caps included)Individual Flow Control adjustment for each port - Permits precise flow adjustment for each low-volume headEasy-Access Filter - Reduces nozzle pluggingInternal Pressure Reduction - Ideal for retro-fitting underground irrigations systemsCarded
Makes use of a few of my 3D print designs:
https://www.amazon.ca/gp/product/B0049PJMYC
I have a recirculating deep water culture setup that is very similar. Instead of running larger return lines, I have my pump on a mechanical timer that turns on for a few minutes about 10 times a day. Enough flow to keep fresh water in the bucket, but slow enough to avoid a water backup.
Also. Use a water manifold like this to distribute water to the buckets:
Orbit 67000 8 Port Adj Flow Manifold https://www.amazon.com/dp/B000H9AI9C/ref=cm_sw_r_cp_api_i_Na9GDbHAAHMP2
I'm not that sure where to find guides. There are a lot of premade kits available, check amazon or home depot or similar stores. You can purchase the individual parts or just purchase a kit.
Here is a typical water pump, this one is the smallest and cheapest I can find on Amazon, or close to, as it takes very little flow to supply the drippers. Don't let them run dry though, reservoir should always have water in it.
I currently use this bad boy to split from 1/2 inch hose from a water pump to the thinner spaghetti hose, I think it's 1/4 inch, that leads to the drippers. The trick to using this manifold is finding a fitting to go from 1/2 inch hose from the pump to the required thread for the manifold, which is garden hose size. I use a totally standard 1/2 inch threaded fitting that is stocked at all my local hardware stores. You can adjust flow on the manifold but I prefer not to, just leave it and let the drippers modulate flow.
Instead of a manifold, you could also find some way to go right to spaghetti tubing from the pump, and just run one master line to all the plants, and use a tee for each dripper.
You could also run the 1/2 inch supply line as your master line and puncture a hole in it with this or this and just use a little fitting like this to run the spaghetti hose to each dripper/plant, but I feel like these connections are prone to leaking. It is a very popular way of setting up drip systems though. With less than very many plants I would go with a manifold or spaghetti hose with tees.
I like this style of dripper because it sends a consistent amount of water to the plants and I adjust volume by setting an electronic timer (24 hr/7 day timer) to run the right amount of minutes per day, the amount of times I want. Math is nice.
So basically parts list can fluctuate pretty heavily depending on how you want to do it.