Reddit reviews Orbit 67101 Inline Multi-Stream Emitter 10 Count

I can post more pictures of the setup tomorrow if you want, basically since I live in an apartment building I use the water pressure from our reservoir that sits 7 floors above my apartment.

I have connected a timer to the wall that turns on a solenoid valve twice a day for 5 minutes.

The water comes out from under the sink on the balcony, goes to a 1/4" tubing that is then reduced to a 1/8" to fit the drip system.

I have just about enough water so that the water starts to drip form under the vases and since where I live is quite warm the plants usually like that.

I have set up the system 2 weeks ago so I still didn't had time to see if I should reduce or increase the water but this can be easily done by changing either the time the valve stays open or the amount of water that leaves the drip valve.

Here are the links for the stuff I used (similar):

Solenoid Valve

Timer
I like this model so you can connect the wires to the inside of the plug and keep you plug usefull.

Dripper I used these ones but I could not find then on amazon.

These look like might work aswell, and would solve one of my complaints about mine that is, when I need to change the amount of water I end up having to twist the water line witch messes up the direction of the rest of the line.

That's basically it, just pay attention to the diameter of the tubing and the voltages you use everything else should work just fine.