Reddit Reddit reviews Philips 12361B1 H9 Standard Halogen Replacement Headlight Bulb, 1 Pack

We found 7 Reddit comments about Philips 12361B1 H9 Standard Halogen Replacement Headlight Bulb, 1 Pack. Here are the top ones, ranked by their Reddit score.

Automotive
Automotive Lights & Lighting Accessories
Automotive Light Bulbs
Philips 12361B1 H9 Standard Halogen Replacement Headlight Bulb, 1 Pack
Original equipment quality seal for the most reliable performanceAlways replace in pairs to ensure a symmetric light beam from both bulbs on the road. Headlights dim over time.Headlight bulbs by Philips, for over 100 years we have been continuously innovating automotive lightingWhen installing a new bulb, never touch the glass. Either use gloves or paper towel when handling.
Check price on Amazon

7 Reddit comments about Philips 12361B1 H9 Standard Halogen Replacement Headlight Bulb, 1 Pack:

u/GonadsOfWrath · 7 pointsr/fordfusion

>The factory headlights even with an LED upgrade isn't going to cut it during the winter time.

I agree, LED "upgrades" will only help you see worse in the wintertime. Unfortunately, propaganda and misinformation and fake news surrounding LED kits for vehicles have reached North Korean levels.

----

What I would do if I were driving a '15 Fusion in Alaska at night:

Stick with halogens bulb and keep the old, factory halogens as spares in your car.

This is how much high-performance halogen bulbs can help you. They can help you see 60+ feet further compared to factory bulbs. These are the best H11 bulbs for your low-beam headlamps. Your Ford has H11 bulbs in the low-beams as stock equipment.

Alternatively, you can switch from H11s in your low-beam to H9 bulbs. H9 bulbs draw ~10 more watts than H11 bulbs, but put out 75% more lumens. The slight bump in power draw might actually be beneficial in helping you melt the ice on your lamps! Here are the best H9 bulbs. You will have to trim a little metal and plastic tab on the bulb to match the dimensions of the tabs on your H11 bulbs, but it's not extremely difficult.

Either the high-performance H11s or the H9 bulb swap will enable you to see far better than your stock setup with its long-life, low-output H11 bulbs, or any sort of LED conversion.

And before I get a light bar, I would consider upgrading your high-beams and perhaps see if that'll cut it. Your stock high-beams use H7 bulbs, which only put out 1600 lumens. 2100 lumen H7 bulbs are coming out soon. So, if you ran H9's in the low-beams and the special H7's in the high-beam, you'd be looking at 8400 raw lumens from your Ford without even touching a light bar or LED bulbs. And the price of these 4 halogen bulbs should be below $50. Even without the special H7s, you're looking at 7500 raw lumens with just H9s.

----

If you do need a light bar, I would get a good light bar such as this one. No, this is definitely not the cheapest light bar out there, but it's definitely reliable, as it's made by an American firm (JW Speaker).

u/existentialporcupine · 1 pointr/mazda6

I did the H11 to H9 conversion (on youtube, literally just cutting off a little tab) and my lighting problems were solved

​

How to: https://www.youtube.com/watch?v=sY1kaMRVz8o

Bulbs i used that work really well and cheap: https://www.amazon.com/gp/product/B003YMPN3A/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

u/commiecat · 1 pointr/subaru

I got the interior LEDs from eBay. I'd strongly suggest a trim tool if you don't have one (Amazon or Harbor Freight). I later replaced the cargo area LED with a larger LED array for more brightness; the other LEDs are all great and are similar color range of the approach lights if you have them.

The sway bar cuts back on the wobble you might feel on the back end when you turn. For me it made it feel a bit more sedan-like. I read through this extensive thread and decided to give it a go. It's $100 so not too much of an investment considering the overwhelmingly positive reviews. Pretty easy to install with the right tools. Ramps help but aren't necessary.

For the headlamps I bought these H9 bulbs with these harnesses. Both bulbs will work but the connector is different. I opted for the affordable harness so I could cut those up instead of the factory connectors so the bulbs would fit.

I've not actually used my oil drain valve yet as I'm just shy of 5k miles. Did my first oil change at 3k to get it installed and I'll probably change it again at 6k to test it out and get my intervals back on the 6k multiples.

Again, install was straight forward and I did use a torque wrench to tighten. The nipple is still within the plastic shroud and I have no worry about it hitting anything (if it does I have other problems). No leaks or anything.

u/hypageck · 1 pointr/4Runner

07 4th gen here, but still somewhat applicable.

I did the low beam to H9 swap and LOVE it. I rarely run my high beams anymore, and I live out in rural country central VA.

Been running them for almost 4 months now with no issues. I do get flashes from oncoming traffic once in a while, but I think that's more due to me needing to re-aim my lights after the lift.

I ordered the standard Phillips H9 bulbs [from Amazon](Philips 12361B1 H9 Standard Halogen Replacement Headlight Bulb, 1 Pack https://www.amazon.com/dp/B003YMPN3A/ref=cm_sw_r_cp_apa_eB4OAbTHBYA68) for $8 each (they're up to $11 now).

u/milspek · 1 pointr/SubaruForester

They're just basic Phillips H9 bulbs. When the bulbs are actually brighter they don't need to use any marketing gimmicks.

Philips 12361B1 H9 Standard Halogen Replacement Headlight Bulb, 1 Pack https://www.amazon.com/dp/B003YMPN3A/ref=cm_sw_r_cp_apa_undRBbEY32SH9

You'll need two.

u/yoyomah20 · 1 pointr/fordfusion
u/onsit · 1 pointr/subaru

Those bulbs are shit. See. http://www.danielsternlighting.com/tech/bulbs/blue/good/good.html

You went to 1380 lumens, which is rather low. You could be at 2100 lumen, and see everything.

H11 -> H9 low beam mod = 55% increase in light output
9011 high beam mod = 48% increase in light output

Your best is to do a little mod, which can be done with a nail clipper (you just cut away some metal from the bulb housing. And use H9 bulbs instead. (http://www.subaruoutback.org/forums/138-gen-5-2015-present/186450-headlamp-modification-h11-h9-retrofit.html).

These are the best fucking halogen low beams bulbs you can fit into a Subaru (https://www.amazon.com/Philips-Standard-Halogen-Replacement-Headlight/dp/B003YMPN3A).

If you want to do the same mod to your highbeams, you can do so by swapping to an HIR 9011 bulb.(http://dastern.torque.net/Mods/HIRmod.html) (https://www.amazon.com/Philips-9011-Standard-Replacement-Headlight/dp/B00480J5CW)