Reddit reviews SEAFLO 4" In-Line Marine Bilge Air Blower 12V 270 CFM Quiet Boat White
We found 6 Reddit comments about SEAFLO 4" In-Line Marine Bilge Air Blower 12V 270 CFM Quiet Boat White. Here are the top ones, ranked by their Reddit score.
Voltage: 12V DC, Flow capacity: 270 CFM (Cubic Feet per minute)Current Draw: 6 Amp Draw, Suits 4" Diameter HoseProvides ventilation for engine compartments, galleys, bilges and headsWhite ABS plastic construction with built-in molded mounting bracketsCorrosion proof design and water resistant motor casing for use in the marine environment
No, they're inline fans. They only work went the software is running in the background. They are there to simulate wind speed. I only use the when in F1-ish position. An awesome gent over on the iRacing forums wrote the code for the fans. After another aswesome gent posted a way to run the fans via PC.
something like this? Yes.
Just to throw another option out there - I use 12v bilge blower fans (similar to: SEAFLO 4" In-Line Marine Bilge Air Blower 12V 270 CFM Quiet Boat White https://www.amazon.com/dp/B0166S2PA2/ref=cm_sw_r_cp_apa_i_SscDCbTQMY3Y9). If you go with a 4" you can just use dryer vent to get it outside. You can also put a motor adjustment switch on it (12V Motor Speed Controller, DROK DC Motor Driver Board for Brush Motor 7V-60V 20A 420W PWM Control 12V 24V 36V 48V Regulator Cooling Fans Dimmer Governor Pulse Width Modulator with Adjust Knob https://www.amazon.com/dp/B00DVGGWC0/ref=cm_sw_r_cp_apa_i_vvcDCbXK0FE4Z). These move a lot of air, which could help depending on the size of your run, etc.
Hello everyone,
First time spray booth building and I have some questions. I heard using a Bilge fan will reduce the chance of catching fire when spraying lacquer. This is the model that I am looking at. Does anyone have any experience with using a Bilge fan and can let me know if it is too loud?
Thank you
Also, any opinion on this instead? https://www.amazon.com/dp/B0166S2PA2?psc=1
I forgot to answer your actual question.
No, using PC fans is simply not suitable for this application. There just isn't enough surface area on the fan blades to create the amount of static pressure required to effectively pull enough air through a good carbon filter. If you want to go small and cheap, maybe try a smaller filter like a 4", coupled with an inline bilge blower.