Reddit reviews SharkBite U514LFA End Cap Plumbing 1/2 In, PEX Fittings, Push-to-Connect, Copper, CPVC, 0.5 Inch, Brass
We found 3 Reddit comments about SharkBite U514LFA End Cap Plumbing 1/2 In, PEX Fittings, Push-to-Connect, Copper, CPVC, 0.5 Inch, Brass. Here are the top ones, ranked by their Reddit score.
INSTALLS IN SECONDS: No special tools, soldering, crimping, or glue; Just push the adapter to create a watertight unionVERSATILE: SharkBite plumbing fittings fit copper, CPVC, and PEX pipe and connect all 3 types in any combinationLEAD-FREE: Made of high-quality forged DZR brass that is lead-freePREFERRED BY THE PRO: All SharkBite PEX tubing and silicone wrap meets the same standards for commercial and residential plumbing applicationsMADE IN THE USA: All SharkBite valves, clips, joints, and adapters are manufactured and tested in the USA
Go buy sharkbite caps. After demo you can slap those on the pipe and turn the water back on the rest of the house.
SharkBite 1/2-Inch End Cap, Push-to-Connect, PEX, Copper, CPVC https://www.amazon.com/dp/B002STXVFW/ref=cm_sw_r_cp_apa_i_oG7mDb29M299G
If you can verify that there's pressure behind those caps, i.e. that they're plumbed into the main system but sealed, then it will be very easy to finish. Any plumber could do it in 45 minutes max.
The drain too, just requires a fitting glued on to accept the chrome or plastic P-trap from the sink. That's even easier...like 10 minutes.
If you're wanting to get into this a little, go ahead and do this:
Buy a drain trap, and a suitable adapter for your drain pipe (probably 1.5" PVC, but possibly 2". Can't tell from the photo. Measure the outside, and tell the home labyrinth attendant, he'll get you the right one.). That'll get your drain attached, as long as there's one in the sink. If not, you need a sink drain to attach to as well.
Then get yourself this sink kit. This is what lets you connect your hot and cold supply lines to the faucet. No soldering required, just a clean end, push on, and you're done.
If you want to be sure this is hooked up right: turn off the water to the whole house and relieve pressure by turning on a faucet that runs. Make sure no other faucets run at all. Take a hacksaw and cut off the cap, staying as square as you can. Have a bucket ready, and have someone else SLOWLY turn on the water. If you get water out of both pipes, you're golden, and you're ready to proceed with the sink kit above. If not, slap a couple of these end caps back on the pipes and call a plumber...it needs more work.
Sharkbite cap https://www.amazon.com/SharkBite-U514LFA-Plumbing-Fittings-Connect/dp/B002STXVFW?ref_=w_bl_hsx_s_hi_web_9315591011