Reddit reviews Speedball 4121 Deluxe Hard Rubber Brayer - 80 Durometer Roller With Wire Frame - 4 Inches
We found 3 Reddit comments about Speedball 4121 Deluxe Hard Rubber Brayer - 80 Durometer Roller With Wire Frame - 4 Inches. Here are the top ones, ranked by their Reddit score.
HARD RUBBER BRAYER – This synthetic rubber (80 durometer) brayer comes in handy for light carving and gluing applications. It’s also ideal for rolling down prints and other graphic projects.COMFORTABLE HANDLE – The plastic handle on the rubber brayer is super comfortable and feels great in your hand.QUICK, EASY CLEAN – Clean the roller off with soap and warm water. Wipe clean with a paper towel or washcloth.MADE IN THE USA – The Speedball Deluxe Hard Rubber Brayer is proudly made in the USA.
You can go out to any place that sells lumber, home depot, lowes, or just a hardware store. Birch plywood is a good start, but it splinters a lot when cutting it. I would recommend MDF board, it cuts easy and is great for beginners. After that youll just need a set of woodcutting tools, I would suggest getting this set, since its cheap and still pretty good. Use a sharpie to draw/plan out your image and make sure youre cutting out the negative spots, the parts that you want to keep white. You'll also need ink, you can get speedball (its cheap), a brayer, and a wooden spoon to burnish the image on to paper. As far as paper goes, I would suggest using mulberry at first, its thin so you can see what you are doing during the burnishing process.
So the steps as follows:
To add to this I recommend using a brayer roller for adding the pressure. Something like this.
Here's a good set of 2 for under $10:
https://www.amazon.com/dp/B07GRSLNXY
If you're looking for something of higher quality, these two are highly recommended:
https://www.amazon.com/dp/B003IFY622
https://www.amazon.com/dp/B000BYVMFC
Either way, I honestly wouldn't recommend Cricut branded.. they're simply too expensive and not worth the price.