Reddit reviews Zircon StudSensor e50 Electronic Wall Scanner / Edge Finding Stud Finder / Live AC WireWarning Detection
We found 6 Reddit comments about Zircon StudSensor e50 Electronic Wall Scanner / Edge Finding Stud Finder / Live AC WireWarning Detection. Here are the top ones, ranked by their Reddit score.
The Zircon SS e50 electronic stud scanner detects the edges of wood and metal studs and alerts you of live AC wires helping you easily find studs and avoid hazards while mounting a TV, hanging cabinets, installing garage shelving and moreStudScan mode locates the edges of wood or metal studs up to 0.75 inches (19 mm) deep while DeepScan mode locates targets up to 1.5 inches (38 mm) deepWireWarning Detection indicates the presence of live, unshielded electrical AC wiring while scanning in StudScan and DeepScan modes.Operating Temperature:20° to 105°F (-7° to 41°C)Patented "Over the Stud" Indicator and SpotLite Pointing System ensure the e50 provides trustworthy results while the ergonomic grip design allows for comfortable use regardless of hand sizeOne fully charged 9V battery, not included, is required for the stud scanner to run at optimal performance
Buy this along with your new tv, OK?
https://www.amazon.com/dp/B01HTFHOEI/ref=cm_sw_r_cp_apa_HtUxzb4937R5H
In the USA the 1959 NEC introduced a rule that hasn't changed much to today; the “6 and 12 rule”:
210-22
>“receptacle outlets shall be installed so that no point along the floor line in any usable wall space is more than six feet, measured horizontally , from an outlet in that space.”
Communities/States sometimes make the most current NEC the local code right away, but it is not unusual for places to lag one or more code cycles behind. So it is quite possible that a mid 1960s house would have much larger distance along a wall between outlets, because they only needed to conform to the "20 foot rule" introduced in 1940 or the 1956 "12 foot rule".
Or, if there are outlets near enough to the corner on both adjacent walls, it could have been be compliant without an outlet on the 10' long wall.
Also, in some rural areas there may not have been code enforcement at the time that the home was built or added-on to, so the home was built to whatever standard the builder was accustomed to follow.
When outlets are put in at the time of build, they tend to be at consistent height. So if you have suspicion that there might be an outlet-box with the outlet removed hiding under the wallpaper, you can rub fingers along the wall at outlet height in order to feel any hollow or concealed cover behind the paper. You can also use a sensitive non-contact tester if you have one, to attempt to detect active wires behind the paper. Or use a stud-finder that has current detection. Or use a tone&probe "breaker finder".
The chances are very very small, but if you'd like peace of mind, get a stud finder that detects ac voltage. Something like this
https://www.amazon.com/dp/B01HTFHOEI/ref=cm_sw_r_cp_apa_KUbSBbA5Y5XNR
A decent electronic stud finder
Get a stud locator, then you'll know where the framing is.
Best 25 bucks I've spent as a home owner. stud finder