Best polyvinyl acetate adhesives according to redditors
We found 5 Reddit comments discussing the best polyvinyl acetate adhesives. We ranked the 4 resulting products by number of redditors who mentioned them. Here are the top 20.
We found 5 Reddit comments discussing the best polyvinyl acetate adhesives. We ranked the 4 resulting products by number of redditors who mentioned them. Here are the top 20.
3/4" heatshrink to go over the ESC's. 0.25" I think to go over your battery cables. 5/8ths maybe to cover XT60 connectors. Wire sleeves aren't needed. I hold stuff down with double sided tape. or a wrap of electrical.
Thin solder, you'll thank me. Along with a pencil tip for your iron. You'll want ?14G? wire to solder a power lead, confirm this. I also didn't have a 5V step down to power my FC on my first build. You'll want one. Many PDB's have one integrated. That makes it easy.
Purple Loctite or your frame will vibrate itself apart, Real quick. Don't use this on Nylon, and don't get it on the motor shaft, but it is extra important to use on motor mounts though. Just be careful.
A battery buzzer that you can solder onto your PDB is nice. Adhesive velcro is good if you want to use that in addition to battery straps. Either that or hobby foam. A parallel charging board is nice to have so you don't lose an entire day charging batteries. Learn to use it.
I personally replace all my stock hardware with Aluminum Cap screws because I want to cut weight and I hate dealing with stripped hex heads. Not needed though. Zip ties are good to have. A bundle of black ones will work. I've found the colored ones are more prone to breaking. They are good to hold antenna wires.
90deg pin headers are nice. My FC didn't come with those, only straight, and stack height is a real problem with straight pins. Extra props. You'll want those. 8mm socket to remove prop nuts. 3mm allen key. USB to micro USB cable to update your FC. Some XT60 connectors.
Beyond that, I'm sure I'm over looking some things. After a couple of builds you just have extras of stuff so you overlook.
https://smile.amazon.com/gp/product/B000PS9S3M/ref=oh_aui_detailpage_o09_s02?ie=UTF8&psc=1
http://www.fastener-express.com/aluminum-fasteners-nuts-washers.aspx
https://smile.amazon.com/gp/product/B006GOL5CQ/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1
https://smile.amazon.com/gp/product/B0094EJG3K/ref=oh_aui_detailpage_o03_s01?ie=UTF8&psc=1
https://smile.amazon.com/gp/product/B00004Z4BV/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1
https://www.amazon.com/dp/B00LXLHU6W/ref=cm_sw_r_other_apa_i_QY65AbBBBZFDZ
This is the one that I use, 4 by 8 inch sheet, you can cut it to size.
It's doable. This stuff is what we used to use mounting Cu components to watercooled Al heatsinks.
https://www.amazon.com/Burndy-P8A-Oxide-Inhibiting-Compounds-Container/dp/B008KLX2RY
I just got my ender in Feb so I haven't really hammered it with anything I just got on my second spool last week my first spool was hatchbox then I grabbed some of the amazon basics stuff (my roll was garbage) so I decided to give CHEP's Filament a try and it prints as good as the hatchbox spool I had if not better