(Part 2) Top products from r/ak47

Jump to the top 20

We found 22 product mentions on r/ak47. We ranked the 98 resulting products by number of redditors who mentioned them. Here are the products ranked 21-40. You can also go back to the previous section.

Next page

Top comments that mention products on r/ak47:

u/JakesGunReviews · 6 pointsr/ak47

Any ammo will be fine. As for what zero works best, etc., I recommend taking a look at this and going from there. You'll learn a lot about your rifle and how it was used historically.

There really isn't much to watch out for; if you get a side-mounted optic, just make sure you know how to install one. One thing's for certain, though, clean your muzzle device and its threads (as well as the front sight block's threads it mates with) as often as possible after a firing session. This is doubly so if you're firing corrosive surplus. My latest AK purchase was an SGL 31-61 and it looks like the previous owner shot 30 rounds, maybe 60, through the rifle, but it must have been 7N6 surplus. Everything was clean but he'd never removed the muzzle device to clean it. I had to depress the detent for the device with a punch and run a screwdriver through the brake's main exhaust port area. This was the only way I could get enough leverage to rotate it free since it had started rusting. That rust was fusing the metal of the brake and the metal of the FSB threads together, effectively turning it into what would eventually become a "permanent" muzzle brake. Clean that up or it will get nasty fast. I've seen a brake that only ever saw 7N6 through it -- like 1k+ rounds of it -- that had not been properly cleaned except maybe once or twice during the first couple hundred rounds. It has been permanently rusted into place for the past five years. Only hope the owner has for replacing it is drilling out the FSB pins and replacing the entire assembly.

Keep that brake and threads clean and you'll be fine. If you don't have time/products to clean it same-day, at the very least, remove the brake from the rifle. It'll keep any rust that's forming from fusing the two items together. I make it sound a lot worse than it is, but with muzzle brakes after firing corrosive 7N6, I get paranoid. Commercial ammunition isn't as big of an issue: just keep it oiled enough to where you can still remove it by-hand and you're good.

u/ThrownAwayMosin · 3 pointsr/ak47

> neither extreme or violent in a method to accelerate the projectile rapidly.


......Thats why guns never explode because smokeless gently pushes the rounds down the barrel with with light and gentle pressure. Oh I get it now./s

You are arguing semantics with someone who doesn't give a fuck. Try to change your walls mind and you might have better luck. And hey dumb ass what do hemorrhoids feel like? oh that's right they feel like butthurt. Since I was never a dick to you till after you called me one, you must have hemorrhoids, because you were pretty butt hurt over a mild joke, that was more in agreement with you while making fun of I.O., RAs,C39 owners, yet you took it personally. Most likely because you were already in butthurt due to the hemorrhoids, Hence why I recommended it for you. Why you think my pussy has a yeast infection Idk, it's not like you can see me sitting here scratching at this itchy thing, But I promise it's not from you, you are no where near sweet enough.

And now the downvotes are hurting your feefees? Don't worry I'll have a talk with them.

Guy stop downvoting him. He obviously can't handle the downvotes and needs a safepace where he can hide from all the libtard cucks who aren't even here yet he felt the need to bring that up.

Also might want to double check those numbers, Unless these are 300g containers. But surely you know what you're talking about and didn't throw up a random thing you read once.

u/cygnosis · 5 pointsr/ak47

I wanted to believe this was photoshopped, but if it is somebody has gone to great lengths for a prank. It's a real thing on amazon, though they say it isn't released yet.

u/pervian · 2 pointsr/ak47

Why not just spray coat the parts with some type of clear coating to keep the look of everything? Would something like this work to keep the 'look' including the sticker in place as well as the shellac chips as they are? I'm not too knowledgeable on the paint finishing side of life.

http://www.amazon.com/Krylon-6-Ounce-Crystal-Acrylic-Coating/dp/B001K65K26

u/Rohkii · 3 pointsr/ak47

If you dont have a gun case you should probably buy one if thats what you are talking about.

Id suggest a Plano 42in if your a cheap bastid: http://www.amazon.com/Plano-Weather-Tactical-Case-42-Inch/dp/B00E2217I6/ref=sr_1_1?ie=UTF8&qid=1462998489&sr=8-1&keywords=plano+42

or a Pelican 1750 if you like your cases with caviar: http://www.amazon.com/PELICAN-1750-000-110-Long-Rifle-Case/dp/B000AOMA1S/ref=sr_1_1?s=sporting-goods&ie=UTF8&qid=1462998488&sr=1-1&keywords=pelican+1750

The only gun upgrade you should do right now is a sling, grab a romy sling off k-var, and learn how to use it. Slings are awesome.

u/the_duck17 · 1 pointr/ak47

When I refinished my stock that was poop I just used Citristrip and then I wanted a darker wood so I used a stain conditioner then stain, followed with shellac I mixed up from Shellac.net. Lightly sanded at the beginning just to knock down a rough edge.

Another rifle got the same treatment but ended up using Linspeed for that one since it was a Yugo Mauser. Didn't like how shiny it was so for the last coat I knocked down the shine with some 0000 Synthetic Steel Wool, really happy with how that came out.

u/Somnio64 · 1 pointr/ak47

i just found this which recommends this. For only $8 I might as well give it a shot.

u/mrmax1984 · 1 pointr/ak47

It's not really. It takes about 5 minutes with a dremel, using a thin grinding stone tip. Just grind a bit, then test-fit the standard mag for fitment. You can get it to the point where it will still accept the Vepr magazine in addition to the standard/surplus magazines.

Here's a brief video detailing the process.

Arguably the bullet guide installation is more difficult, since you have to be very careful while drilling and tapping. If you botch the magazine catch, you can always install an aftermarket upgrade, but you won't be able to easily repair a botched hole in your receiver.

u/izhevsk1807 · 4 pointsr/ak47

Apart from the coffee-table part, could anyone compare this to Ezell's "Kalashnikov: The Arms and the Man" (and for that matter, Ezell's original and the expanded collector's edition published after he passed away)?


Links:
https://www.amazon.com/Kalashnikov-Arms-Edward-Clinton-Ezell/dp/0889352674
https://www.amazon.com/AK47-Story-Evolution-Kalashnikov-Weapons/dp/0811722473/ref=sr_1_9?s=books&ie=UTF8&qid=1540313532&sr=1-9

u/Dexter-the-Cat · 2 pointsr/ak47

I don’t think the length matters provided that it will fit in a .30 caliber barrel and it’s long enough to get down a 16” barrel as they all are. This is what I’m using:


Tipton Deluxe 1-Piece Carbon Fiber Cleaning Rod 27-45 Cal. 36", retail pk https://www.amazon.com/dp/B000BYAKDC/ref=cm_sw_r_cp_api_i_ZaiDDb56G9GFM

u/Modex14 · 1 pointr/ak47

> HK black duracoat

damn you guys are going to make me go broke with all these projects. This seems like a good idea. I've never seen it posted on the FAQs.

http://www.amazon.com/DuraCoat%C2%AE-Semigloss-Black-Firearm-Finish/dp/B000M67TTC

another project for later this summer it looks like now.

u/otacon237 · 1 pointr/ak47

any chance you could find a narrow enough grabber tool and try that?

u/beardedbassguy · 3 pointsr/ak47

I have more than most, but not near enough. Stored in ammo cans, and my wife makes me some desiccant packs. Much cheaper than the little silica packs, and you can reuse them by microwaving them.

Basically, she takes a material called muslin (it's very thin, see through even) makes a pouch the size of the ammo can. Fills with a thin layers of silicate/desiccant beads (you can find a big pack online or at a Micheal's/Hobby Lobby)and sews it shut. Put it on top of the ammo and close the lid. I have a very thick one in my gun cab as well.

About every 6 months or year I take them and microwave them to get the moisture out (make sue your beads can do this) and throw them back in. Make as many as you need.

EDIT:
Muslin: http://www.amazon.com/Wide-Cotton-Muslin-Natural-Fabric/dp/B003D7C4VA
Beads: http://www.amazon.com/Bulk-Buy-Panacea-Silica-Crystals/dp/B004B3L600/ref=sr_1_1?s=arts-crafts&ie=UTF8&qid=1414444009&sr=1-1&keywords=bulk+silica

u/IrishSeaMonkey · 16 pointsr/ak47

Vietnam was self inflicted.

You should really read Afgantsy

u/ink_addict · 2 pointsr/ak47

Here is the link to the kit.

u/greekplaya990 · 3 pointsr/ak47

RIT Aquamarine.

You need to boil the hell outta them and for HOURS (on and off the highest heat) and I think Vinegar is what helped turn it 50% darker and absorb the dye better in these Magpul Sand pmag Magazines since they got WAY darker once I did a third - 7th boil with it. People reported doing these quick but it took like all day and overnight to get this color.

Also, the magpul window will NOT absorb dye at all which is awesome, no matter how long you dye, no need to cover them or worry about the M3 mags with them.

u/Swiss_Cheese9797 · 1 pointr/ak47

If you're really worried just get this

u/TheJamesRocket · 2 pointsr/ak47

>Soviet losses on the eastern front were 7,000,000 to 5,500,000 for the Germans, if the Soviets were sending ''millions of untrained conscripts to their deaths'' I want to know what the Germans were up to.

>(Soviet loses are massively inflated by the millions of Soviet soldiers who died in German captivity.)


It depends on who you ask. There is no single, definitive source for the losses sustained by either side during the eastern front. However, this book has estimates that are highly unflattering for the Soviets.

The USSR sustained 8,773,200 KIA and MIA, with 5,880,800 P.O.W. Thats a total of 14,654,000 losses. The Germans sustained 3,526,500 KIA and MIA, with 1,415,100 P.O.W. Thats a total of 4,941,600 losses.


In other words, they suffered 196% more losses by the wars end. For every 1000 Germans soldiers lost, the Soviets lost 2965 soldiers.