(Part 2) Top products from r/lgv40

Yes, but not curved on the actual display panel but the edges.. glass screen protectors will not be easy due to the bezels getting Smaller and the curved edges but at least you still have a shot at it unlike Samsung's which the actual display is curved too, causing a distortion and practically impossible for a glass protector. They're still working on a glass screen protector on the V40, sometimes it takes a few months until a good one releases. The one available now will leave a small amount of halo around it but it's better than nothing. Your second option is wet install screen protectors.. the matte one looks nice from IQ shield.

Here's a pic from Amazon. I don't recommend the "full coverage" one because they fall off, just get the traditional full adhesive with shortened edges.

https://imgur.com/a/p7LR96G


So far these two are your best options:


[3-Pack]-Mr Shield for LG V40 ThinQ [Tempered Glass] Screen Protector with Lifetime Replacement Warranty https://www.amazon.com/dp/B07GXH9DY9/ref=cm_sw_r_sms_apa_iu22Bb1XWYVRF


LG V40 ThinQ Screen Protector [2-Pack, Case Friendly], IQ Shield Matte [Anti-Glare] Bubble-Free Screen Protector for LG V40 ThinQ TPU Film https://www.amazon.com/dp/B077QTTZFN/ref=cm_sw_r_sms_apa_yU22BbG8Z7EB3


Or just wait until a manufacturer creates a good working one. It took several months until the V20 got a perfectly working full coverage glass screen protector (the PThink brand).

Here is the color.

https://imgur.com/a/AKba2TN

It is this color for every message thread and when looking at all the conversations.

I literally just got so as far as batter life and screen time I cant' really say. It seems to be doing fine. It came with about 55% battery life and after downloading about 125 apps over wifi and spending about 45 mins on a fast charger, its still at 50%.

​

Out of the box it is running V405UA10d, which if it is consistent across carriers is similar to TMobile's V405TA08b which is described as their launch software version. There were no software updates out of the box. I did notice that the sticker seal on the box was cut and a secondary QC Passed sticker was placed over it.

​

Initial thoughts on the camera is that the front cams are definitely better than the V30s and the rear cameras are solid, especially in manual modes.

​

Accessories wise, I went with the Supershieldz Tempered Glass which applied very easily but does have quite prominent edges.

https://www.amazon.com/gp/product/B07GV3M1FZ/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1

​

I ordered a cheap, clear case (I like the look of a skin under a clear case) until an option from Spiegen or other more reputable manufacturer comes out. It doesn't come until tomorrow, so we will see how it plays with the more prominent screen protector.

https://www.amazon.com/gp/product/B07HK2JHLV/ref=oh_aui_detailpage_o01_s01?ie=UTF8&psc=1

​

Hope this helps!

​

​

So far I am loving the phone, and thank you for replying it is nice to see real people giving there personal experience, I would still love to see jerryrigeverything get his hands on one. I personally bought 2 cases for it tonight, the spigen full armor one and a fusion case one someone on this recommended. However when it came to the screen protector itself I went against the glass this time as on my v30, s9+, s7 and other phones I have had they are not working out well for me so I went with a film that has pretty good reviews. Links to what I bought below.

Screen Film: https://www.amazon.com/gp/product/B077QKVF6T/ref=ppx_yo_dt_b_asin_title_o00__o00_s00?ie=UTF8&psc=1

Spigen Tough Armor:

https://www.amazon.com/gp/product/B07GQDNHZL/ref=ppx_yo_dt_b_asin_title_o01__o00_s00?ie=UTF8&psc=1

Ringke [Fusion-X]:
https://www.amazon.com/gp/product/B07HRNH2CH/ref=ppx_yo_dt_b_asin_title_o02__o00_s00?ie=UTF8&psc=1

+1 to the "anything Anker" suggestion. I also bought these wall chargers:
https://www.amazon.com/dp/B07C2QG8BB/ref=cm_sw_r_cp_apa_i_UnLHDbHQYP99A

And these cables:
https://www.amazon.com/dp/B01JCNZCK8?ref=ppx_pop_mob_ap_share

Along with a few of those 3-in-1cables for other devices, and have been very happy. The chargers are quick chargers and do a good job giving a quick boost. The cables feel like they're nicely built and I can't recommend having long, 10ft cables enough. Ran mine up the back of the couch into the cushions so people can charge while watching TV and have a few in the shop.

I have the thin Spigen case on mine, and it works great. https://www.amazon.com/gp/product/B07GQCN63S/ref=ppx_yo_dt_b_asin_title_o08_s00?ie=UTF8&psc=1

For screen protector, I went for the premium option:
https://www.amazon.com/gp/product/B07JQT17Q4/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1
For this one, TAKE YOUR TIME. It's pricey, so be really patient, as the process takes time, but the results are outstanding for me. Doesn't attract dust or fingerprints very much and touch sensitivity is great. No rainbow effects either. Admittedly, I messed up my first one due to going too quickly, so I had to order a second one and redo it and it was flawless the second time.

Hey, wanted to chime in on this since I've had a lot of experience with the last 3 V-series phones. Because the phone isn't triggered into high impedance mode (50ohms and above) is WHY your IEMs are so quiet. The sub 50ohm headphones get detected, and then the V30 and V40 lowers the amp power. I'm not sure why they do this, but to get around it I got a short and cheap 3.5mm male to female output so that it can drive my IEMs way better. Now, it thinks it's in aux mode. However, if you do this, you'll have to first connect the cable into the phone, and then your IEMs into the cable. Not both at the same time. Now, not only is it way more than enough volume for my IEMs, it sounds fuller at all volumes.

Something like this:
https://www.amazon.com/LEMENG-Female-Headset-Extension-Cable-2Pack/dp/B01LRXP43G/ref=sr_1_8?ie=UTF8&qid=1543568122&sr=8-8&keywords=1ft+3.5mm+male+to+female

or this:
https://www.amazon.com/FAAEAL-Conductor-Impedance-Cancelling-Professional/dp/B07FMG8144/ref=sr_1_3?ie=UTF8&qid=1543567848&sr=8-3&keywords=3.5mm+impedance+adapter

But I honestly haven't tried the second option...and I'm not sure what it would do differently, or even be harmful for the IEMs.

This one works good through my Spigen case on my V30. Pretty good quality too. I picked up for half price a couple months back.
https://www.amazon.com/dp/B07CZ8KBR4/ref=cm_sw_r_cp_apa_g081BbWEADB5D

The specs on GSM Arena also list the V40 as supporting Quick Charge 3.0 only. I have a ton of stuff I charge at the same time and have gotten very good speeds from this 6 port charging station made by Aukey that features two QC 3.0 ports.

Seems like all of these are the same case from different sellers, and I got the same one.
I also ordered this: https://www.amazon.com/gp/product/B07H53ZGXF/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

TPU bumper with PC back. Similar to what I was using on the V20. Won't have it until Monday though.
I want a screen protector, but going to wait for an Invisible Shield type to hopefully cover the full screen.

Super glue. I do it to keep my finger loop thing on (https://www.amazon.com/dp/B00JSS4HBI/ref=cm_sw_r_cp_apa_Hvw
-BbE7EYRAW)

I personally like the screen protectors with the black borders around the edge.

LG V40 Screen Protector, Poetic [HD Clear][Anti-Fingerprint] Premium Tempered Glass Screen Protector for LG V40 (2018) - Clear/Black https://www.amazon.com/dp/B07HNNBJLC/ref=cm_sw_r_cp_apa_i_Xu.QCbRG94WHY

The poetic fell off of my phone after one hard drop on a hardwood floor. Adhesive is poor. Great protector no rainbow effect.

SEEU LG V40 ThinQ Glass Screen Protector-(3 Pack) Anti-Fingerprint Anti-Scratch Ultra-Thin HD Clear 9H Hardness Full Coverage Silk Print Black Tempered Protective Film for LG V40 / V40 ThinQ 6.4" https://www.amazon.com/dp/B07HQLXKDR/ref=cm_sw_r_cp_apa_i_qx.QCbNJD9VRX

I bought the seeu protectors next. You get three in the package. The adhesive is much better. These protectors are very reflective which I don't like. There is a small rainbow effect down the middle but it doesn't bother me.

https://www.amazon.com/dp/B00YLFTOF2/ref=cm_sw_r_cp_apa_i_C6aMDbXG2AP5X

Here's the wrap


https://photos.app.goo.gl/X1a4Fep1KTzL8iK2A

And here are the only cool pictures I have of the wrap

I bought this one, hoping it is OK. Unfortunately, I won't receive it for a week or two, and my V40 doesn't come until next Wednesday. Once I try it out, I'll post my results. https://www.amazon.com/gp/product/B07GRXF34Q

My exact model phone is the LG LM-V405UA.

However, in looking back at my old Amazon order, the details on the charging pad I have now say

>【FAST CHARGE MODE】(Output 10W Max) : APPLICABLE Fast charge mode ONLY supports the 6 devices: Samsung S8,S8 Plus, Galaxy S7, S7 Edge, Note 5 and S6 Edge Plus.

So I guess there's my problem. I'll have to get a new pad that's compatible with the V40's fast charging.

I ordered this one:

https://www.amazon.com/Anti-Scratch-Flexible-Silicone-Protective-Transparent/dp/B07GXBRZ5K

This one by Anker

VE Monk.
Venture Electronics VE MONK Plus earbud earphone https://www.amazon.in/dp/B01J0S4AAS/ref=cm_sw_r_cp_apa_i_cuCUDb5SEWK46

If you think the Ringke case is ugly (I do) and want a minimal slim case, try this:

​

https://www.amazon.com/ThinQ-Arkour-Minimalist-Smooth-Surface/dp/B07J2WLZBL