Top products from r/sleeperbattlestations

We found 7 product mentions on r/sleeperbattlestations. We ranked the 7 resulting products by number of redditors who mentioned them. Here are the top 20.

Next page

Top comments that mention products on r/sleeperbattlestations:

u/emberstaff · 2 pointsr/sleeperbattlestations

One option is to rethink cooling. You could use an all-in-one liquid CPU cooler that mounts to a 120mm fan so you don't need side intake. You could fit the 5.25" bays with fans for additional air flow from the front. You could install additional fans in the PCI brackets. Or you could make peace with modding.

Another option is just browsing PCPartPicker for cases until you find a modern one you like the look of, although I feel like you're getting away from genuine sleeper status by doing that. Find something reasonably humble in appearance like this case, or pick anything you like the look of and spray paint it beige.

u/aphetica · 2 pointsr/sleeperbattlestations

I Googled the following:

120mm mesh fan grill

120mm wire fan grill chrome

Comes in black or chrome depending on what aesthetic you're aiming for; adjust search terms based on your fan size.

u/oeuvre · 1 pointr/sleeperbattlestations

wear gloves, spread this on evenly with a brush https://www.amazon.com/Salon-Care-Creme-Developer-ounce/dp/B004OKDW20

wrap up the yellowed plastic in clear plastic wrap

put it in the sun outside, rotating every 30 minutes for even spread, for a few hours depending on temp

u/GaryLaserEyes55 · 3 pointsr/sleeperbattlestations


I painted all of the faceplates to match the case as close as I possibly could. All of the front panel components were black:

EverCool Dual 5.25 in. Drive Bay to Triple 3.5 in. HDD Cooling Box https://www.amazon.com/dp/B0032UUGF4/ref=cm_sw_r_cp_apa_i_ybi2Cb4W2XVGV

Sabrent 74-in-1 3.5" Internal Flash Media Card Reader/Writer with USB Port, Black (CR-USNT) https://www.amazon.com/dp/B00GAKX34E/ref=cm_sw_r_cp_apa_i_g7g2Cb0S7E9C2

u/Mistral-Fien · 1 pointr/sleeperbattlestations

The lack of exhaust vents is another concern. You might need to cut a hole at the top and put an 80mm fan as an exhaust; alternatively, cut a hole at the top rear, just above the rear I/O panel, then put a centrifugal fan like this one.