Reddit reviews 3D Printer Extruder Nozzle Head Cleaner KIT .3mm .35mm .4mm .45mm .5mm bits (2 each) + Multi-functional BIT HOLDING TOOL
We found 1 Reddit comments about 3D Printer Extruder Nozzle Head Cleaner KIT .3mm .35mm .4mm .45mm .5mm bits (2 each) + Multi-functional BIT HOLDING TOOL. Here are the top ones, ranked by their Reddit score.
Will clear nozzles and produce finer printsShipped in protective plastic caseJapanese made tungsten carbide bitsFrom Daewon Industries3.5" comfortably held nozzle cleaning pin-vise tool
I had this happen with a composite filament. I did all that I could to try and unclog the nozzle but I was unable to.
What ended up doing was purchasing an aftermarket nozzle set as well as a new heat barrier tube. This would be cheaper than getting an entire new hot end, as long as your other components work out.
Here is my thread on my issue: Here
I also ordered nozzle cleaning bits from amazon after the fact, which I have not used yet. https://www.amazon.com/gp/product/B00PXETKUY/ref=oh_aui_detailpage_o04_s01?ie=UTF8&psc=1