Reddit reviews Ace Remote Switch Extension Cord (1PC-002-015FWH)
We found 6 Reddit comments about Ace Remote Switch Extension Cord (1PC-002-015FWH). Here are the top ones, ranked by their Reddit score.
16/2 SPT-2, 15'10 amp125 volt1250 wattPVC insulation
You could use something like this
That switch is for low voltage, but you have the right idea. An an extension cord would be allowed, as this is not a permanent installation.
Something like these may interest you:
https://www.amazon.com/Remote-Switch-Extension-Cord-1PC-002-015FWH/dp/B000GAS3HG
https://www.ebay.com/itm/Foot-Switch-with-3-Outlet-9-foot-Power-Cord-Black-/302450857422
How about get something like this, cut off the switch portion, wire it into your project with a strain relief bushing on your enclosure?
how about this
https://www.amazon.com/Remote-Switch-Extension-Cord-1PC-002-015FWH/dp/B000GAS3HG
It’s an older remote switch. The cord coming out of it should have a male/female plug left on table or wall to turn on lamps with hard to reach switches (any lower power device would work also). More modern example:
https://www.amazon.com/Remote-Switch-Extension-Cord-1PC-002-015FWH/dp/B000GAS3HG
I put an external switch on my aquarium stand that controls the power to my wavemakers, return pump and aqua lifter. I flip the switch off for feeding. When I flip it back on, the return pump fills up the HOB overflow, and the aqua lifter restarts the siphon on the overflow box. I also added a siphon break on my in-tank return about 1/4" below the surface of the water. I get a couple of gallons at the most that siphon back into the sump when I kill the return pump.
I am using something similar to this:
https://www.amazon.com/Ace-Remote-Switch-Extension-Cord/dp/B000GAS3HG