Reddit reviews FoamTouch Upholstery Foam Cushion Medium Density Standard, 4" L x 24" W x 72" H

It's not attractive.

​

Put into perspective, sitting back in a recliner, legs spread.

Top layer of foam has a half-circle cutout the same size as the launch. Rounded the protruding edges a bit.

Bottom layer is set back a bit. I decided to make the overall thing a bit big to start with so it would hold the launch well. Might shrink it some as i fine tune it.

The whole thing sits flat on the recliner in front of me and holds the unit at the right position, it never falls over or has problems.

​

Currently I sit it on one end of a towel, facing me and lay the other end over the top and it provides a complete towel cover for the brace. Was working out the fine tuning of it before I attempt to make a vinyl cover for it.

My next thing after making a cover is to see if I can add velcro on the rounded inner and put some on the launch so it can be positioned to ride a bit higher than against the pubic bone. Currently I use a rolled up hand towel to raise it.

​

I have a few other things I've done. Some case modes and suction mods. Was half-debating posting some "Boggleby's Tips" kind of posts but wasn't sure if anyone would care.

​

Anyway here's the foam brace (2 views) the black stuff along one edge isn't dirt or muck, it's where I used a pen to mark the cut. :)

​

https://imgur.com/gallery/CBVjaL7

​

This is the foam I used, we had some for another use. (If this is an affiliate link i cannot tell, please don't shoot me if it is): https://www.amazon.com/FoamTouch-Upholstery-Cushion-Density-Standard/dp/B00UKG6S1E/ref=sr_1_1?keywords=FoamTouch+Upholstery+Foam+Cushion+Medium+Density+Standard%2C+4%22+L+x+24%22+W+x+72%22+H&qid=1562470221&s=gateway&sr=8-1

​

Adhesive spray to bond the two layers that will not damage teh foam: (Trust me, do not use this indoors, if you get overspray you are going to regret it): https://www.amazon.com/gp/product/B0000AZ735/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1