Reddit reviews RAYSUN 10 Pack 30cm 3Pin Male to Female JR Servo Extension Wire KK MWC Eagle Control Board - 22# Cord

>Oh man, thanks! I HAVE some of those cables! I bought them on Amazon and they just came in!

Yup, those will work just fine, depin the white one and just use the black and red making sure they are lined up right.

>I'm using it to connect my d4r-ii to the FC.

Excellent, I'm running that same set up and so far I'm really liking it. I think your naze32 was the rev5, I got the rev6, they just cleaned up some of the pins, but they are all still there. The cool part is you can do telemetry with that combo. I'm having the quadcopter battery voltage sent to my radio and set up some alarms on it to warn me when my battery is getting low. It let's me worry about flying and not having to worry about how much battery life I have left.


>My last question for you, I can take that red wire, soldier it to pos and black to neg on the PCB.

As long as you are hooking them up to the 5v output you are good to go.

>But there is a 3rd, white wire. Can it just get scrapped?

Take it out and scrap it.

>If that's all it takes, I'm set!

That all this takes. There are a bunch of other things to sort out, but just take one at a time and you'll get through this. :)

Oh man, thanks! I HAVE some of those cables! I bought them on Amazon and they just came in!

I'm using it to connect my d4r-ii to the FC. Splendid! My last question for you, I can take that red wire, soldier it to pos and black to neg on the PCB. But there is a 3rd, white wire. Can it just get scrapped? The black part is what I was calling a dupont connector. Was going to just plug that into the pins right beside where the ESCs plug in.

If that's all it takes, I'm set!