Reddit reviews Shop-Vac 9520262 5-Gallon 4.5-Peak HP Hang Up Wall Mounted Wet/Dry Vacuum

We found 1 Reddit comments about Shop-Vac 9520262 5-Gallon 4.5-Peak HP Hang Up Wall Mounted Wet/Dry Vacuum. Here are the top ones, ranked by their Reddit score.

4-1/2-horsepower motor delivers impressive suction and airflow of 165 cubic feet per minuteWall mountable for centralized cleaningGOT DIRT? Shop-Vac's full line of products includes cordless, rechargeable wet dry vacuums, automotive vacuum systems, air movers, attachments & more. Whatever the job, Shop-Vac has you covered!AN AMERICAN ORIGINAL: Shop-Vac offers the most complete line of vacuum cleaners, bags, filters, attachments, kits, & other cleaning tools available for home, industrial, & commercial applications.TOUGH & DEPENDABLE: Shop-Vac Corporation is the recognized world leader in wet/dry vacuum cleaners. Since 1965, we have made innovative, high quality vacuum cleaners, filters, bags, & other accessories.

Check price on Amazon

1 Reddit comment about Shop-Vac 9520262 5-Gallon 4.5-Peak HP Hang Up Wall Mounted Wet/Dry Vacuum:

u/theredsuit · 2 pointsr/firewater

You want somethign like this (scroll down to see the pic)? http://homedistiller.org/forum/viewtopic.php?f=15&amp;t=25554

find a cylinder that has a diameter less than the 5gal pail. For example: https://www.amazon.ca/Shop-Vac-9520262-5-Gallon-4-5-Peak-Mounted/dp/B00005AXI1 (you need a new vacuum right? Also you won't be able to use a 5gal pail using this as your shape, get a primary 6/7gal fermenting bucket at your wine making shop)
Buy a coil of copper pipe (25') works well. http://www.rona.ca/en/copper-pipe-0144032--1

3)Make small spacers from 1/2" copper pipe (3/4" is long enough)

4)Get some wire that's easy to twist tie.

5)Take the Vacuum canister by itself and flip it over. Now place your coil on top and while holding the inside cut end of the pipe, SLOWLY (the coil I'm using is very malleable. Meaning it's soft and easy to kink.) pull the coil out and around the canister until the coil can drop around the canister. Now just the first couple loops need to be tight to start. Let the rest hang in loose loops. You'll pull those in as you work your way down.

6)Now about 10" in (to give yourself some space to move the end around for fittings.) place your first spacer and wire it to the top loop. Pull the first coil around holding it tight to the can, sort of smoothing the coil against it while pulling it. Go firm and slow, try not to pull it down but go along the can close to the coil above. Using another piece of wire, tie the spacer to the loop below. Do this again about a 1/3 way around. Keep doing this until your fingers are numb and bleeding and you'll have a solid coil.
Solder the copper pipe pieces to the coil to ensure a solid build. Remember to use flux!
you can figure out the rest of your fitting after that.