Reddit reviews Tinker3D Antminer S7 S9 S9i E3 T9 L3+ D3 A3 V9 X3 120mm Fan Duct Cooling Shroud to 5 Inch Vent Hose
We found 3 Reddit comments about Tinker3D Antminer S7 S9 S9i E3 T9 L3+ D3 A3 V9 X3 120mm Fan Duct Cooling Shroud to 5 Inch Vent Hose. Here are the top ones, ranked by their Reddit score.
Antminer Fan Duct Shroud to connect 5 inch vent hoseImproved airflow compared to 4 inch designDesigned to fit standard 120mm fans using existing screwsMade in USA and 3D printed using ABSWorks with Antminer S15, T15, S9, S9i, E3, T9, V9, X3, L3+, D3 and A3, DragonMint, and Whatsminer
Fan duct shrouds work perfectly. They’re apparently used in bitcoin mining, but are great when repurposed for swamp coolers.
Once you have the shroud mounted just slide 5” tubing over it and hose clamp it in place.
I'm just going to assume running an air conditioner or cooling device is out of the question. There are ways to lower temperature without necessarily increasing energy consumption. You can try using some ducting to move the hot air out of the room where you keep your miner. Take a look at these HERE. Simply detach the fan on the rear of the S9 and screw those on. You can even use the same screws the S9 came with. Then attach some ducting, maybe something like THIS, and you can take the hot hair away from the machine.
If that is not an option, I would consider not running the machines during the day. If you have to run hot machines, you want to stay under 100°C. You do not want to run them to the point where they can reach the 115°C automatic shut off point. If they automatic shut off you are almost guaranteed to have fried chips.
[Here] (https://www.amazon.com/gp/product/B01M0N30QC/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1) are 5" shrouds in stock on amazon in case you wanted them.