Reddit reviews VIM Tools HCT1050 10-Piece Half-Cut Torx Driver Set
We found 2 Reddit comments about VIM Tools HCT1050 10-Piece Half-Cut Torx Driver Set. Here are the top ones, ranked by their Reddit score.
Half/Cut TORX, Torx length cut to ½ the normal depth, increases strength and improves fastener engagement.Fits into the fastener and makes the feeling better with less wiggle or wobbleKnurled body for fingertip control.1/4-Inch square drive, with 3/4-Inch overall length, the shortest drivers available.Limited Lifetime Warranty
You probably will never need XZN for your car unless you need to remove the seats. That uses an XZN 10.
I really like this set for Torx
VIM Tools HCT1050 10-Piece Half-Cut Torx Driver Set https://www.amazon.com/dp/B000VUM6BU/ref=cm_sw_r_cp_apa_AABTybDZ4RPRA
If you buy that and the Neiko set you linked to you'll have all the Torx you need. The small half cut ones are nice for hard to access fasteners and they grip the edges better as they half cut design goes deeper into the fastener so you're less likely to round out rusted bolts.
Which has pretty much no benefit over a regular old 6 point bolt. At least in that size. Even in larger sizes, the benefits are negligible and a normal bolt would do just fine in place of an e-torx.
And proof e-torx is retarded: A T-10 and an E-10 aren't the same size.
edit: Also, E-torx is different than the half cut torx sockets I'm talking about.