Reddit reviews Xcelite 170M General Purpose Shearcutter, Diagonal, Flush Jaw, 5" Length, 3/4" Jaw length, Blue Grip
We found 6 Reddit comments about Xcelite 170M General Purpose Shearcutter, Diagonal, Flush Jaw, 5" Length, 3/4" Jaw length, Blue Grip. Here are the top ones, ranked by their Reddit score.
Low profileSuperior blade by-pass shear cutting actionGreatly reduced mechanical shock delivered to the workFeatures blue grips
So, the only way to make those zipties safe for anyone, is to use flush cutters. I've worked in too many tight spaces where a single ziptie does more damage than a knife.
https://www.amazon.com/Xcelite-170M-General-Shearcutter-Diagonal/dp/B0002BBZIS/ref=sr_1_1?ie=UTF8&qid=1518524260&sr=8-1&keywords=xcelite+flush+cutters
No....... Wrong... Twisting them can over tighten them and can still leave sharp corners. Trim the ends with a small pair of flush cutters, or telco shears if you're pro.
flush cutters example
For flush cutters/snippers (don't need two tools really) get either:
Even the cheapest ESD tweezers are ok for holding components, get a kit that includes angled ones if you're going to do a bunch of SMD.
These are good also: https://www.amazon.com/Hakko-3-SA-Non-Magnetic-Microelectronics-Applications/dp/B00FZPEWI6
Xcelite 170m for anything thinner than 14awg. For everything thicker, ChannelLock 337's
The Xcelite's are my favourite. You can feel when you've gotten through insulation and are touching copper before cutting through it.
It was this pair https://www.amazon.ca/Xcelite-170M-General-Shearcutter-Diagonal/dp/B0002BBZIS/ref=sr_1_2?ie=UTF8&qid=1478968368&sr=8-2&keywords=cutters . They snapped while i was cutting a piece out of the runner. I got a pair of diagonal cutting pliers from Canadian Tire to finish the job, they were slightly less maneuverable , but much more durable.
LPT: Cut the zip ties flush!
http://www.amazon.com/Xcelite-170M-General-Shearcutter-Diagonal/dp/B0002BBZIS/ref=pd_sbs_indust_2