(Part 2) Top products from r/fleshlight

Hey, glad you enjoy it. I will answer with how I do stuff but everyone has their own methods and you just need to get yours.

1 I got Gun Oil with a pump, I use 1 squeeze, you should adjust to your own preferred amount of lube, and squeeze it in the hole, I grab my two fingers, finger the sleeve make sure it's spreads nicely and don't forget about the lips either. The rest goes on the head of my penis, smear some one the shaft, my fingers are half the size of my gentleman(got small fingers) so it's not necessary to spread it all deep 9/10 times it goes in smoothly that 1/10th time just circle your fleshlight around to spread it.

Bonus bit:p since I'm shaven I like to smear in a circle around my gentleman so I can swirl my fleshlight around lol, but this is something you can skip of course.

2 I'm usually very lazy when it comes to this, I don't want to ruin the mood by getting my hand sticky and having to clean it mid session, so I just squirt a little bit inside the entry hole depending on how "wet" I want it to be, and just circle the fleshlight around at different depths if you overdid it with the amount of lube, you can use a towel to dry your penis.

3 I'm not familiar with Astroglide, but this one on amazon is the one the one they also sell on the mainsite, it's waterbased lube should be perfectly safe. But astroglide sells all kinds of different lube, like silicon and even with flavours, I suggest you avoid all special lubes and of course the oil and silicon ones as well if you ever have any question if a certain lube is safe, you can always ask here, better to be safe than sorry.

4 Cleaning, I just did my business, walking over to my sink, I wash my hands, I remove the sleeve, give it a thorough rinse with cold water after a while I start scrubbing the inside with my fingers, you can use both holes to enter. set the water to warm, apply fleshwash or isopropyl 70% and apply it while giving it a thorough scrub again with my fingers, after that I give it a good rinse with warm water, shake it to get most of the water out and let it dry. I use fleshwash almost after every use, and isopropyl before storing my fleshlight.

Now I'm going to start on the case, which is just like doing the dishes, grab a bowl of hot water, apply soap(never use soap on the sleeve btw) and scrub it down with my dedicated washing-up brush. you unscrew both top and bottom caps clean those, pop the ring off at the top, no worries fits only 1 way. and you make sure you pay extra attention on the threads, and there is a ring on the bottom of the inside that also needs some special attention. now dry it all with a dishcloth and assemble it again. once every 3 to 5 uses depending on time frame, I use isopropyl to thoroughly clean my cases.

Can't help you with hiding your sleeve while drying, maybe someone will come along with some tips and tricks.

5 Question do you have the bottom cap fully closed? cause Angel is a somewhat wider sleeve and shouldn't be tight it all, could also be that you use to little lube or a combination of the two or you were first in line when God handed out girth sizes.

What will help you cure DGS is abstaining from tight masturbation so no hand and no super tight sleeves, it's not about learning it's about fixing your nerve endings. lets say you wouldn't masturbate for a year that would fix your DGS, but there is no fun in that, so having a fleshlight that you can use while fixing your DGS is just win win.


if you got any other questions or need follow up just ask.

As far as "need" goes, that's it. Just make sure the lube is water based and unscented. Gun oil h2o seems to be the favorite around here, but there are cheaper options.

Here are the possibilities along with everything you should know beforehand...

Talc - It's gonna come sticky or get sticky over time. There are two options for getting rid of this. 100% pure talc is one of them and corstarch is the other.

https://www.amazon.com/Silver-Cup-Premium-Talcum-Powder/dp/B07N6MRWNB

ILF used to talc all sleeves until Johnson and Johnson got sued for using contaminated talc that caused ovarian cancer. This is a Johnson and Johnson problem and not a talc problem (hence the reason it's still for sale). Take an old sock and pour some in it. Use a good rubber band to keep it shut and dab the sleeve with it. A little bit of the powder will come out each time and get rid of the sticky. I also do the same thing with the fingers of a cheap clothe glove to do the inside of it. You might not need this as much with a pilot. If you choose to go the cornstarch route, you can do the exact same thing only you have to do it almost every time. Talc is a once every couple months type of thing.

70% Isopropyl alcohol - Basically rubbing alcohol only some have other ingredients in it. You don't want the other ingredients as it may hurt the sleeve.

https://www.amazon.com/70-Isopropyl-Alcohol-32-oz/dp/B0006Q0062

Currently sold out, but you can find it from their own online store. An empty spray bottle to put it in is a good idea too. Be careful if you go with an old one that had cleaner in it because the cleaner may have left a residue in the container that can mix with the alcohol and hurt your sleeve over time. This is for disinfecting once every month or two. Just give the inside a spray and rub all the different little nooks and crannies with it and let it dry. I know somebody who has been using these things for years and never done this, so.......Up to you. I paid 3 bucks for the alcohol and 1.5 for the spray bottle.

The only other real need I can think of is how are you gonna dry it? Anything fibrous leaves lint behind. Especially if you don't talc or cornstarch it. I tape a microfiber cloth for wiping sunglasses and tape it around a chopstick or a piece of a plastic coat hanger in a way that it wraps around it and enables me to push the cloth through and take out any excess water really quickly. Improves dry time immensely and is reusable. With a pilot, ou might not need the stick. Just the microfiber cloth might do the trick.

To let it finish drying, it's best to have it hanging vertically somehow. Taking a wire hanger and bending it in a way that you can slide it on it so it hangs up and down so any excess water can drip out is great and you can hang it in a closet or just about anywhere until it dries. One of the more important things about these is to NOT put it in the closed case while damp or wet. That moisture can lead to mold or mildew that pretty much means you have to toss it. That's also why even though I'm a talc user, I also have cornstarch. If I ever put a sleeve away for an extended period of time, I alcohol it to clean up anything that may be in there and it also makes it dry super fast. I then cornstarch it to absorb any moisture that might build up before next use. If this is your one and only, this is a bit of overkill. You'll probably be using it a lot and hence cleaning it a lot.

In closing, I talc sleeves about once every 6 months or so. They probably get the alcohol treatment once every couple months. You can do without these, but I recommend them. Especially the powder treatment (talc or cornstarch) and making sure it's dry before you put it away is very important. If for some reason you can't find a way to hang it up overnight in a closet, then maybe a small fan to blow it dry.

>Wanted to know if Argo Corn Starch is safe to use?

Any corn starch is safe as long as it's just corn starch.

>I have safety concerns about sanitation, but to warm and clean my fleshlight, is using my restroom sink clean? I know it's the most common method everyone uses but I don't know if I'm just being paranoid with using an area where people spit in and brush their teeth in.

It doesn't actually have to go into the sink or onto any surfaces. Just hold it in your hands while cleaning it (eg, I use disposable vinyl gloves). And I have bus tub in case I need to set it down.

Just use common sense.

>Also I don't have a fan or the likes to dry my fleshlight, would I be fine with just leaving it out to try? Time isn't an issue for me to dry, but many posts I've seen it seems like a fan is an essential to drying out your FLs.

A fan isn't essential. It just speeds up the air drying process. Using decent quality paper towels should make it 98% dry. After than you can air dry it with or without a fan.

>Is it advised to turn your fleshlight inside out to clean and dry? I've seen very mixed responses to this.

It's completely unnecessary. And it can overstretch the material which can damage the sleeve.

Cleaning and maintaining a fleshlight is a lot easier than people make it out to be. Just use common sense and don't over complicate things.

Hey guys, I hear you about wanting the best handsfree way.

Everyone with a launch should look into buying this Exact neck pillow - It fits the launch like a glove, and you can prop it up any position and holds in nicely in place for true handsfree:

https://www.amazon.com/Cabeau-Evolution-Memory-Travel-Pillow/dp/B004ZIDXK2/ref=zg_bs_3732121_15/131-2263745-7988302?_encoding=UTF8&psc=1&refRID=J91DCE49YKCFZF4WEK91

Don't search for safes, those are huge, heavy, thick, and made to withstand actual abuse. You just don't want people accidentally coming across a sex toy. Search lockboxes. They are boxes, with locks. Things like this.

Alternately, /u/bustnuts100's suggestion for a toolbox is a great one. My only concern would be that people might need a tool and reach for it.

I'd say to go with the lockbox, and if asked, just say it has some bullshit in it that you can say is sentimental but no one else would really care about other than you. Photos of your grandparents as kids or something.

Different. Just get cornSTARCH.

Should be very white and a fine powder. Like when they show cocaine in Hollywood movies.

Unlike cocaine it should be quite cheap.

https://www.amazon.com/ARGO-Cornstarch-35-Ounce/dp/B0045DMLXM

It's used among other things to thicken sauces in cooking.

It fits nicely in a guitar stand - You can go to town if you lower it enough or look for a way to attach it to something else


https://www.amazon.com/Stage-XCG4-Tripod-Guitar-Single/dp/B0006NDF8A/ref=sr_1_4?gclid=EAIaIQobChMIqamWluiS5AIVCK_ICh3DJwDSEAAYASAAEgIzM_D_BwE&hvadid=178325920455&hvdev=c&hvlocphy=9003540&hvnetw=g&hvpos=1t1&hvqmt=e&hvrand=15211846610240655117&hvtargid=kwd-24104570&hydadcr=29616_10190110&keywords=guitar+stand&qid=1566351000&s=gateway&sr=8-4

how does the water drip out with the hanger? check out baby bottle dryers or a paper towel holder

https://www.amazon.com/Spectrum-Diversified-Paper-Holder-Chrome/dp/B000F5IB60/ref=sr_1_9?s=kitchen&ie=UTF8&qid=1505431251&sr=1-9&keywords=paper+towel+holder

https://www.amazon.com/gp/aw/d/B001IBIXZO/ref=ya_aw_od_pi?ie=UTF8&psc=1

https://www.amazon.com/InstaMorph-Moldable-Plastic-12oz-White/dp/B003QKLJKQ/ref=sr_1_4?ie=UTF8&qid=1526608515&sr=8-4&keywords=instamorph

https://www.amazon.com/SentrySafe-1170BLK-Fireproof-Security-Cubic/dp/B004QWZIMI/ref=sr_1_8?ie=UTF8&qid=1481092534&sr=8-8&keywords=fire+safe

Socker boppers mate, i have a review somewhere.

https://www.amazon.com/Big-Time-Toys-Socker-Bopper/dp/B004SCELN8