Reddit Reddit reviews 12 Piece Panther Inverted Cone Bur Set Sizes 0.60 to 2.30 MM Jewelry Making Burs

We found 1 Reddit comments about 12 Piece Panther Inverted Cone Bur Set Sizes 0.60 to 2.30 MM Jewelry Making Burs. Here are the top ones, ranked by their Reddit score.

Beading & Jewelry Making
Jewelry Making Kits
Arts, Crafts & Sewing
12 Piece Panther Inverted Cone Bur Set Sizes 0.60 to 2.30 MM Jewelry Making Burs
Constructed from high-quality hardened tool steelIncludes: 0.60, 0.70 (x 2), 0.80, 0.90, 1.0, 1.2, 1.4, 1.6, 1.8, 2.1, and 2.3 mm bur sizesMounted onto 3/32" shanks
Check price on Amazon

1 Reddit comment about 12 Piece Panther Inverted Cone Bur Set Sizes 0.60 to 2.30 MM Jewelry Making Burs:

u/Lost_Thought ยท 3 pointsr/guns

Engraving, join me in ruining perfectly good guns!

Edit:

Starter kit for hand engraving as a cheap person

  • Square Graver
  • Graver Handle

    Starter kit for the wild child with a dremmel

  • Diamond Burrs

    OR

  • Tungsten Carbide burrs (these need a 3/32 collet)

    Full hobo mode

  • Take a spade bit (look in the trash, where they belong)
  • Grind it down to a graver shape freehand
  • EDIT: Heat treat so that it actually works. (repeat multiple times because you are using a torch and a glass of water like a poor person)
  • Grab a stick
  • Drill a hole slightly smaller than the diamater of the shaft of your improvised graver
  • Jam that ducker into the stick like its a handle
  • Grab a small hammer and get to whackerin