Reddit Reddit reviews 6 Pcs 100K ohm NTC Thermistors/Temp Sensor for Reprap 3D Printer-HONTECH

We found 1 Reddit comments about 6 Pcs 100K ohm NTC Thermistors/Temp Sensor for Reprap 3D Printer-HONTECH. Here are the top ones, ranked by their Reddit score.

Industrial & Scientific
Electronic Components
Circuit Protection Products
Thermistors
6 Pcs 100K ohm NTC Thermistors/Temp Sensor for Reprap 3D Printer-HONTECH
Cable length: 1m.Temperature sensor 100KΩ accuracy of ± 1%.
Check price on Amazon

1 Reddit comment about 6 Pcs 100K ohm NTC Thermistors/Temp Sensor for Reprap 3D Printer-HONTECH:

u/dfunk_ · 3 pointsr/3Dprinting

My first guess would be your thermistor being messed up. Make sure it has a solid connection to the board, that none of the wires are kinked or damaged, and that it's properly seated in the heating block. If all that checks out then I would bet it's busted. These Anets were built on the cheap so that wouldn't totally surprise me. You can replace it with something like this. Good luck!