Reddit reviews BIQU Aluminum Raspberry Pi 3B Plus Case Enclosure Box
We found 2 Reddit comments about BIQU Aluminum Raspberry Pi 3B Plus Case Enclosure Box. Here are the top ones, ranked by their Reddit score.
The entire case molded made of high quality Aluminum materialStructure is divided upper case and lower case with four screws (long screws attached to the upper and lower box 4), plus four non-slip wear padsJust Suitable for PI3B Plus motherboard installation, shell design with good heat dissipation, do not have to install the cooling fan or heat sinkUnder cartridge design aircraft wear pads and holes can be fixed on any wall, smooth surface and the buckle bit slot design is perfectionThermal design of the superstructure column, after the lid close contact with the chip, the chip heat dissipation from the work of distributing the cover, the effective protection of the chip time constant work. Bottom box design cooling pad in contact with the chip, the chip work shed heat from the housing, the effective protection of the chip thermostat work to extend the life of the chip
You could use one of these, although if you have the newest 3B+ it won't fit as they moved things around.
I like these Flirc cases, they are a minimalist design and very good at passive cooling. I would prefer the unbranded cheaper version of the Flirc to this kodi one. I think I like the Biqu cases even better, they are a very similar design, all aluminum and less expensive than the Flirc. Keep in mind that these aluminum box pi cases can act as shielding and reduce the range of the internal wifi and bluetooth, so that is something to consider if those are features that you use.
https://www.amazon.com/BIQU-Aluminum-Raspberry-Plus-Enclosure/dp/B07C4K77ZN