Reddit reviews Cloudray 40W PSU Laser Power Supply 110V/220V for CO2 Laser Engraver Cutter MYJG 40W
We found 1 Reddit comments about Cloudray 40W PSU Laser Power Supply 110V/220V for CO2 Laser Engraver Cutter MYJG 40W. Here are the top ones, ranked by their Reddit score.
Good compatibility: it can be applicable to 30-40W Laser Tube manufactured by various factories.Quick response speed and effect,high performance,large cutting power,it also can prolong laser tube service life.Easy control: the start and stop of laser can be easily controlled by TTL level.The power supply has output open circuit protection and a buttonto test to output laser manually.Application: Sculpture and cut acrylic,fabric,double color sheet and rubber etc.
I had the same thing happen. It turned out to be the power supply. I never tested the high voltage on the bad power supply but after replacing it with this one: https://www.amazon.com/dp/B079MHKQXF/ref=cm_sw_r_cp_apa_i_28.hDbP7RKR39
I think my problem was the original power supply overheated and was just generally shitty. The one I replaced it with has a fan 🤷♂️. You just gotta make sure to connect it correctly