Reddit reviews ESP-01S USB to ESP8266 ESP-01S Wireless Wifi Adapter Module Wi-Fi CH340G 4.5-5.5V, 115200 Baud Rate
We found 2 Reddit comments about ESP-01S USB to ESP8266 ESP-01S Wireless Wifi Adapter Module Wi-Fi CH340G 4.5-5.5V, 115200 Baud Rate. Here are the top ones, ranked by their Reddit score.
Document link https://tinyurl.com/y2svtas5, The 01S is DOUT protocol, please choose SPI MODE as DOUT when you program itBaud Rate: 115200, Selectable working mode: On-board toggle switch. UART side for serial TTL debugging by AT commands, PROG for firmware programmingUSB to serial TTL chip: CH340G, please install driver before use itESP-01 serial wifi module can be directly plugged into the yellow pin header without any connection wiresWhat you will get: 1PCS ESP-01S and 1PCS Adapter
Get a programmer like this, with the switch on it to make everything easy peasy
https://www.amazon.com/ESP-01S-ESP8266-Wireless-Adapter-4-5-5-5V/dp/B07KF119YB/ref=asc_df_B07KF119YB/
Thanks for the link. I've read pretty much everything I could find online about this topic in the last several days (which unfortunately isn't a ton) but the main question pertains to using it with the ESP-01S USB to ESP8266 Adapter Module.
Most 3D Printers have Micro USB these days, so my thought process is basically plug ESP8266 -> ESP-01S Adapter -> USB Micro adapter -> 3D Printer board.
Would this sufficiently take the place of soldering to the rx/tx pins on the board? Here is a quick look at the most common method being used right now, but soldering the board is something I want to avoid due to warranty, portability, etc.