Reddit reviews MG Chemicals 824 99.9% Isopropyl Alcohol Electronics Cleaner, 15.9 oz Aerosol Spray, Clear
We found 6 Reddit comments about MG Chemicals 824 99.9% Isopropyl Alcohol Electronics Cleaner, 15.9 oz Aerosol Spray, Clear. Here are the top ones, ranked by their Reddit score.
Dissolves light oils and residues on electronic devices and equipmentA pure IPA, CARB compliant solutionModerate evaporation rateEffective flux removerFood safe – Registered with NSF for use in and around food processing establishments
Get mechanical grade alcohol, 99%, get it in the pressurized spray can, and regular bottle. Disassemble the GPU and get any parts that got coolant on them out of the system.
Get a clean plastic container that can fit the parts you've gotten wet. Put the alcohol in there from the non pressurized n bottle. Place parts in bath of alcohol, use the pressurized alcohol and qtips to clean your parts. Once done, let dry for at least 48 hours in front of a fan.
I've recovered an entire x99 system this way. Good luck.
Edit
https://www.amazon.com/MG-Chemicals-Isopropyl-Alcohol-Cleaner/dp/B005DNQX3C/
Spray
https://www.amazon.com/dp/B005T8PL1Q
> 91% Isopropyl Alcohol
You'll be fine, but 91% is on the low side and I prefer to err on the side of caution. I usually buy 99.9% just to be safe.
Not saying it's shitty for electronics in general, it's also commonly found. But every cleaner has its purpose and apparently the only concern is with the thermal paste. You could also get 99.9% electronics grade aerosol from MG Chemicals, not that you find this commonly in stores.
Remember to get some isopropyl alcohol, for example electronics cleaner and wipe the glass between prints. So you get much better adhesion when there is no residue from previous prints.
https://www.amazon.com/MG-Chemicals-Isopropyl-Alcohol-Electronics/dp/B005T8PL1Q
Very nice and clean!
Before you heat the bed and set the adhesive, I'd peel it off, clean everything with isopropyl alcohol (the good industrial stuff) and attempt to re-adhere the PEI. If you got yours from Amazon, you should have spare sheets of it.
I rolled on 3M onto the bed first, using an empty wine bottle to drive the bubbles out. Then I trimmed the adhesive and carefully peeled off the other side. Next, I bowed the PEI a bit, lined up the 2 corners, and started rolling it on, using a bottle as a pressure roller. Worked out pretty good.
Also...
http://imgur.com/FgHEkyF
Here is the mobile version of your link