Reddit reviews Neoteck DTI Digital Dial Indicator 1''/25.4mm, Fractions/Inch/Metric Digital Probe Indicator, High Resolution: (1/128")/ 0.0005''/ 0.01mm
We found 1 Reddit comments about Neoteck DTI Digital Dial Indicator 1''/25.4mm, Fractions/Inch/Metric Digital Probe Indicator, High Resolution: (1/128")/ 0.0005''/ 0.01mm. Here are the top ones, ranked by their Reddit score.
【Aluminum Alloy Digital Dial Indicator】 Measuring Range from 0 ~ 1 inch (0 ~ 25.4 mm)【High Resolution】 up to (1/128")/ 0.0005''/ 0.01mm; Large LCD Display【Fractions/ Inch/ Metric Conversion】 Switchable between Fractions/ inch/ mm, Suitable for All Kinds of Measurement【Included Rear Cover】 Hole Diameter: 6.5mm, It is Removable and Can be Used on Different Magnetic Base Holder Stand【Zero Setting, with Conveniencet Ports】 RS232 Data Output Interface and LR44 Battery Compartment, East to Replace Battery
I don't recall any of the Finders I've had at the makerspaces I run not allowing prints because of bed leveling issues. In fact, I often will adjust the bed while prints are running if I am not happy with what the auto-leveling software settled on. Usually, it is because the bed needs to be backed away from the nozzle a little bit.
If you want to get real precise with it, I use a dial indictator on my flashforge creator pro that mounts on the X-Axis rods with a 3D printed holder allowing you to level the bed until the dial indictator shows all points on the bed are level. I'm not sure if there is already a model for the finder that exists for this purpose. It'd be pretty easy to make.