Reddit Reddit reviews RCBS Universal 9340 Stuck Case Removal Kit Two Step Process

We found 4 Reddit comments about RCBS Universal 9340 Stuck Case Removal Kit Two Step Process. Here are the top ones, ranked by their Reddit score.

Sports & Outdoors
Hunting Equipment
Hunting & Shooting Accessories
Hunting & Fishing
Sports & Fitness
RCBS Universal 9340 Stuck Case Removal Kit Two Step Process
Made of the highest quality materialsHunting reloading case removersExtracts stuck cases from standard sizer diesDoes not damage the dieTwo-step process
Check price on Amazon

4 Reddit comments about RCBS Universal 9340 Stuck Case Removal Kit Two Step Process:

u/HumidNut · 24 pointsr/reloading

My advice, stop right now. Its done. You don't have the tools to extract that case right now.

Get a stuck case remover, I've used the RCBS Stuck Case Remover 2 with my dies, or ones where the decapping stem and expander ball are removed from the top. With the kit, there's a threaded hex nut that will thread onto your stem, allowing you to back out the expander ball from the neck, and remove the stem. The remaining parts of the kit are used to tap out the stuck case. Don't whale on it, just tap-tap-tap-tap-tap until it starts to move, then it'll come on out.

The more expensive kit, does it with a wider variety of die sets

u/ironshoe · 6 pointsr/reloading

Save yourself the headache and be sure to do the following:

  • Remove any primer crimp if any
  • Check your cases in a case gauge after sizing to make sure they're in spec.
  • Don't be afraid of the lube. Use it.
  • Get an RCBS Stuck case removal kit (because you wont follow #3 above)
u/OGIVE · 6 pointsr/reloading

That is why we should all have the stuck case remover kit

It can be duplicated with a 1/4-20 tap, appropriate drill bit, a 9/16 socket, 1/4-20 x 1-1/2 bolt, and a washer.

u/gwhunter280 · 1 pointr/reloading
  1. Buy a stuck case removal kit

  2. Loosen the decap rod and clamp die upside down in a vise.

  3. Use the #7 -.201"- drill and make a hole through the brass primer pocket.

  4. Tap hole with the 1/4-20 supplied tap.

  5. Place the metal cup over the brass and thread the screw in the case. Tighten the screw and it will pull the brass out of the die.