Reddit reviews SE 6-Piece Diamond Wheel Set - DW13

Id recommend getting a diamond disk for a dremel and cutting it off. To do so you need a small stream of water running on the cut while the disk is cutting to ensure no glass dust is created, as to avoid silicosis. Also wear safety glasses and a dust mask. Once you've cut off the stem I suppose sanding to smooth any rough parts will do. For such a project I would not recommend using heat or fire at all, you'd most likely wind up cracking the glass due to thermal expansion.

Link for diamond dremel cutting wheel

I live in Vancouver. My glass is literally out of a photo frame that I got at Dollarama for $2.5. Nothing fancy.

I cut it to size using my dremel https://www.amazon.ca/2305-Rotary-Tool-Flex-Shaft/dp/B003BYRFH8/ref=sr_1_1?s=hi&ie=UTF8&qid=1501045676&sr=1-1&keywords=dremel with these wheels https://www.amazon.ca/SE-DW13-5-Piece-Diamond-Wheels/dp/B000P49NCC

I attached the glass with 4 binder clips, each measuring 15mm in width. Also from Dollarama; a pack for a Loonie.

Few tips. If you do this, get 2 or 3 frames because you will probably end up cracking your first one as I did. Also be safe. You need to protect your eyes, your hands, and your breath. Again, don't really have to be fancy. For my eye protection I was wearing just my glasses. I also had some good fitting working gloves (any comfortable slightly thick gloves would do) and I wore a surgical mask for protection from glass dust (a slightly damp cloth covering your mouth and nose would work fine too)

Alternatively, you could do this the normal and easy way and use an actual glass cutting tool https://www.amazon.ca/L-TMS-Professional-Handle-Cutter-Cutting/dp/B06X9GRGGD I didn't have one at hand to I just used my dremel.