Reddit reviews SpiritLED 100 Lots LED Strip Light Mounting Brackets,One Side Fixing Clips,Screws Included (Ideal for Non-Waterproof Strip Width 10mm)

We found 2 Reddit comments about SpiritLED 100 Lots LED Strip Light Mounting Brackets,One Side Fixing Clips,Screws Included (Ideal for Non-Waterproof Strip Width 10mm). Here are the top ones, ranked by their Reddit score.

SpiritLED 100 Lots LED Strip Light Mounting Brackets,One Side Fixing Clips,Screws Included (Ideal for Non-Waterproof Strip Width 10mm)

Hollow Distance 10.8mm (3/7"),Ideal for strip width 10mm(3/8"). Hollow Height 1mm(1/25") which is perfect for non-waterproof strip light.Width 4mm (1/6").Suitable for strip lights LED quantity 30/60/120/300PCS per meter. Installation with 2-5 pcs clips per meter.100pcs in a lot.Easy to fix by one screw(included)High Temperature Resistance. Working Temperature:-30degree to 90degreeSafe and secure to hold the strip light

Check price on Amazon

2 Reddit comments about SpiritLED 100 Lots LED Strip Light Mounting Brackets,One Side Fixing Clips,Screws Included (Ideal for Non-Waterproof Strip Width 10mm):

u/Njeff · 12 pointsr/shutupandtakemymoney

I used these, just last night. Worked great. I recommend these to mount them. http://i.imgur.com/3v4IoBA.jpg

u/themellowmedia · 2 pointsr/watercooling

I'm not sure of the brand, just a reel I bought off of amazon and cut to length. They are decent enough. I didn't feel like spending $100 on LED strips. I should point out that the controller that comes with these RGB strips is not the best. But I didn't need a controller, just the RGB strips. Link
In some places I'm using 3M adhesive, and other areas that are more prone to stress and tension I used these little clips.
I drilled, very carfully, about 85% of the way through the front panel maybe even 90%. Then I used what is called a bottom tap, the make the treads.
All screws used on this case are 6-32 (except the mobo standoffs). This is the same screw that Phanteks uses on the case itself. Makes it super easy for assembly not having to guess which screw goes where. Pro tip.
The RGB controller I'm using is from a German company, and there for does not adhere to the same output standards. So I had to map the outputs and cross the wire colors so that the controller would output the proper color to its corresponding channel. That way I wouldn't have to do any guess work when I would make a splice or extension in the RGB run. Fun stuff let me tell you. This took me way to long to get right because one of the ouputs on the RGB controller wasn't outputting the same RGB config as the other 3. After I figured that out it was a breeze lol.