Reddit reviews TEKTON 14191 3/8-Inch Drive by 10 mm Deep Socket, Cr-V, 6-Point
We found 1 Reddit comments about TEKTON 14191 3/8-Inch Drive by 10 mm Deep Socket, Cr-V, 6-Point. Here are the top ones, ranked by their Reddit score.
6-point opening snugly fits hex-shaped fastener heads to apply maximum torque without slippingAdvanced design grips flat sides of fastener heads, not corners, to prevent round offExtra-deep broach reaches over long, threaded shafts to access nutsDetent notches in drive end lock onto ratchets and extensionsMade from premium chrome vanadium steel with a durable mirror chrome plated finish
I too have a 2015 RT Plus Shaker. And back in January I did the swap.
Here's the best price you'll find: https://www.stevewhiteparts.com/exterior-15-18-dodge-challenger-392-6.4l-front-lip-lower-chin-spoiler-mopar-factory-oem-1517lipspoiler?parent=1021
You'll find lower prices on other sites, but then their shipping is outrageous. That site has the lowest price when shipping is figured in.
and here's some other things you will need to get the job done
S&G Tool Aid 19400 Rivet Tool for Plastic Rivet https://www.amazon.com/dp/B007QV2E50?ref=yo_pop_ma_swf You will need at least 35 of these rivets. Just get the 100 piece package as you will waste some of them. They're cheap enough anyway.
PartsSquare 100pcs Fender Liner Fastener Rivet Push Clips Retainer for Chrysler Dodge Jeep https://www.amazon.com/dp/B01B2RC6WY/ref=cm_sw_r_cp_apa_TssiAbG4Q20VM
You may need some of these as well. It's not a bad idea to use them inside the wheel well so that future removals are much easier.
GOOACC Nylon Bumper Fastener Rivet Clips Automotive Furniture Assembly Expansion Screws Kit Auto Body Clips 8mm - 40PCS https://www.amazon.com/dp/B008427D88/ref=cm_sw_r_cp_apap_aldZPoDPnRuY6
You will also need some trim removal tools if you don't have them already. https://www.amazon.com/dp/B01L8GHB7O?ref=yo_pop_ma_swf
You will also need a deep 10mm socket like this and a long extension for the nuts inside the wheel wells. TEKTON 14191 3/8-Inch Drive by 10 mm Deep Socket, Cr-V, 6-Point https://www.amazon.com/dp/B000NY6RBY/ref=cm_sw_r_cp_apa_jCsiAb5EZJ4V3
here's Mopar's instruction for removing the front fascia: https://www.dropbox.com/s/lxe8evqu87l517u/Front%20fascia%20removal.pdf?dl=0 It's much easier to put on the new lip with the fascia off. And I'll warn you that getting the old lip off is a bitch.
The entire job will take about 5-6 hours if you're doing it by yourself. Can cut that time in half if you have someone helping you
https://imgur.com/a/uITIE46
https://imgur.com/a/uTlyeCv