Reddit reviews Zmoon Led Round Light Bar 2PCS 4.5" 140w 14000LM Flood Light Pod Off Road Fog Driving Roof Bar Bumper for Jeep,SUV Truck, Hunters
We found 1 Reddit comments about Zmoon Led Round Light Bar 2PCS 4.5" 140w 14000LM Flood Light Pod Off Road Fog Driving Roof Bar Bumper for Jeep,SUV Truck, Hunters. Here are the top ones, ranked by their Reddit score.
【14 Led Light Bar Chips 】4.5in Round led light bar uses advanced 14 LED chips provide 14000lm,6000k super bright white light, the brightness is far more than similar products of 6 chips, 9 chips. Allows you to see the left and right clearly anytime.【IP67 Waterproof】Zmoon 4.5in led light bar adopts waterproof die-casting aluminum housing and advanced sealing technology,perfectly solves most of the easy water ingress problems encountered in use.The Rustproof and shockproof function,protect the led light bar from rain,wind and sand. This will keep the led light bar clear and bright at all times, which is safer for the driver.【High Illumination】Round led light bar spot lights bring further lighting distance and wider view area,can be placed on the bumper or the roof of the vehicle as driving lights or backup lights.【Adjustable Bracket & 50000 Hours Long Lifespan】Round led off road light bar with adjustable mount bracket,can see different direction clearly.Maximizes surface area for heat dissipation,enhance long lifespan up to 50000 hours.【Application】The 4.5" led round light bars with DC 9-30v working voltage,fits for Off-Road,Heavy Duty,Jeep,SUV,ATV,UTV,Truck,Car,Boat etc.
Ya I just used the bumper bracket hole that was almost directly above the hole for the 4.5" light. Its not perfectly centered so you have to drill the hole slightly to one side but standard angle metal will fit. The flood lights I got are top mounted so I drilled a hole on one side of the angle for the bracket bolt and one on the other side for the light. If you use aluminum angle you will get galvanic corrosion from the steel touching it so you need a rubber gasket.
Also, I got a generic wiring harness from O'Reilly's and snuck it through the fender and dash trim so I could velcro the switch to my steering column. I soldered the wires for the lights and if you have a soldering iron it's not hard. Worst case you use crimp fittings.
I got something like this:
https://www.amazon.com/dp/B07V52K41R/ref=cm_sw_r_cp_apa_i_ovGWDb718KQ88