(Part 2) Best adhesive transfer tape according to redditors
We found 92 Reddit comments discussing the best adhesive transfer tape. We ranked the 24 resulting products by number of redditors who mentioned them. Here are the products ranked 21-40. You can also go back to the previous section.
![Pack of 3 Sheets Size 8" x 12", 3M 9474LE 300LSE Super-Strong Double-Sided Adhesive/Adhesive Transfer Tape, Ideal for attaching digitizers to Phones and Tablets. [9474-08x12-3pk]](https://m.media-amazon.com/images/I/51Jqt2wlaFL.jpg)
While I've never had success with a Rep2X and PLA (except for one roll this one time), it sounds like you've got it extruding fairly well at this point.
So your current difficulty is getting the print to stay stuck to the bed? I'd recommend getting a sheet of PEI (I use 0.03" thickness) like this:
https://www.amazon.com/gp/product/B0013HKZTA
Then cut it to size and stick it to your print bed with this:
https://www.amazon.com/gp/product/B007Y7CZ32
I've had awesome success with PEI and PLA. It sticks great until it cools down, then it comes off easily. Print with the bed at 50C.
Just a word on PEI: All Lulzbot printers now come with a PEI sheet pre-installed, and it works wonderfully for several months until bubbles form and soon you have to replace it. But if that's what you like, cool.
Do note of course that you can buy large sheets of plain PEI on Amazon, along with adhesive sheets, allowing you to install PEI on any printer. If you're lazy, Gizmodorks also sells pre-cut PEI sheets with adhesive already attached.
But also be warned: if the LB autoleveling process somehow screws up because of poor electrical contact and doesn't realize it, your PEI gets messed up real quick, and replacing PEI, as you may know, is quite the pita.
I used the .8 taped and sewn. This tape:
https://www.amazon.com/dp/B00JL8NULS?ref=ppx_pop_mob_ap_share
Yea, VHB is nice to have for really strong permanent bonds, when super glue might be too stiff (or not enough surface contact) and epoxy too messy.
For thinner bonds (like a steel plate to the inside of my phone case for magnetic mounts), while maintaining a strong enough permanent bond, I like ATG tape. I prefer 969, which is strong than 924.