Best brass tubes according to redditors

We found 2 Reddit comments discussing the best brass tubes. We ranked the 2 resulting products by number of redditors who mentioned them. Here are the top 20.

1. K&S Precision Metals 9117 Round Brass Tube, 17/32" OD x 0.014" Wall Thickness x 36" Length, 3 pc, Made in USA

1 mention
K&S Precision Metals 9117 Round Brass Tube, 17/32" OD x 0.014" Wall Thickness x 36" Length, 3 pc, Made in USA
Round rodMade of brassUsed by craftsmen machinists, hobbyists and modelers for a variety of projects17/32 x .014 x 36 inch size
Read Reddit commentsView price

2. K&S Precision Metals 6010 Soft Annealed Brass Foil, 0.005 Brass, 36 Gauge, 12" Width x 30" Length, 1 pc, Made in USA

1 mention
K&S Precision Metals 6010 Soft Annealed Brass Foil, 0.005 Brass, 36 Gauge, 12" Width x 30" Length, 1 pc, Made in USA
Soft annealed foilFor hobby and model buildingEasy to cut and solderEach size is available in a 12" x 30" long roll.
Read Reddit commentsView price
Next page

Top Reddit comments about Brass Tubes:

u/TheBaconheart · 6 pointsr/Nerf

https://www.amazon.com/Precision-Metals-9117-Thickness-Length/dp/B000BQQ3BI

u/hookamabutt · 2 pointsr/weddingplanning

Thank you!! I used a brass “foil” which I found the cheapest on Amazon. This is the one I bought. . I cut out rectangles using scissors, then hammered it with a peen hammer (the one with like, the ball end) then curved and wrapped it around the bouquet, then epoxied the seam, then wrapped it in rubber bands to hold it together and let it set overnight.

Tbh, if I were to do it again, I’d get even thinner brass. I was worried it’d be too thin and just crumple, so this is the one I got after extensive research, but I could have gone one to two gauges thinner and made my life way easier.

Here’s more of my flowers!