(Part 2) Best medical syringes according to redditors

It was always a free needle program. The purpose of which is to reduce the variable amount of HIV infected blood in a relatively consistent quantity of syringes. Junkies gonna junk.

Edit: Oh, yeah, by the way needles aren't expensive in the first place, you can amazon prime them for $20/qty100.

I just make capsules. They are super discreet, super low waste of materials, and easy to regulate your dosage. Plus, I just can't smoke/vape without throwing up instantly.

1. Buy a pack of mints. Consume said mints. Keep the container.
   
   
2. Make your oil, but SAVE YOUR DECARBED BUD.
   
   
3. Buy empty gelatin capsules. I've tried a few different ones, and as long as they're of decent quality (i.e. seal properly, don't have any holes, etc), they all work just fine. Here's what I bought a couple months ago, and will be set for a looooong time.
   
   
4. Buy a couple syringes (without needles). I prefer ones that use an o-ring around the plunger to make a seal, as they don't get stuck as easily, but these will work just fine if you don't have anything.
   
   Optional 5) Add a couple drops of peppermint essential oils to the mixture (I'll take the shit storm for mentioning those, but it really will cut down on the smell and taste a LOT.)
   
   
5. Heat up your oil
   
   
6. Fill your capsules. Put on a show, movie, or music in the background because this can take a little while. I can knock out 50 or so in 15-20 minutes, and that's not moving very fast, so you'll get it down. Protip: if you can, wash out the syringe(s) after filling. The minimal leftover coconut oil will harden up, and fuck up the syringe plunger. If you can't, store the syringe pieces pulled apart so they don't get stuck together.
   
   

• 7a)Here's where you can use that decarbed bud. Get a teeny tiny spoon (or use the handle of one of those syringes), and pack that shit into those empty pills. They should be a different strength than your oil, so make sure to test a couple first, and probably keep them separate. But decarbed bud does still have your thc/cbd in it to get you high. I promise.
  
  

8. Store your medicine pills in that mint container.
   
   
9. Dose as needed
   
   [10] fin.
   
   Edit: spelling. Hope you find what you need!

I went on Amazon and searched both 3mm and 5mm syringes. I wanted mine next day delivery so my choices were sparse. I'm also in Canada so I had less choices than on the American site!

My favorite tip:

Get a 100ml graduate (very small one) and a plastic syringe with a couple inches of tubing (these are often sold to mix oil & gas I guess?) or find some tubing that will fit over a syringe (you don't need a needle and you can buy them online or ask your doctor or dentist, show them a print or whatever if they think you're a junkie - but junkies need needles, you don't).

Use the syringe and tube to draw the syrup from the bottle, then squirt into the graduate - since you're dealing with tiny amounts, like 6ml - this makes accuracy really easy. And accuracy and consistency are they key to dialing in your developing.

You also need photo flo, and film hanging clips, and a packet of negative storage sleeves and some decent scissors. If you don't have a dedicated film drying cabinet - while your film is having its final rinse, run the shower on hot in your bathroom - steam it up good. Rig up a way to hang your film. Turn off the shower and hang the film, and leave the door closed for a couple hours. The humidity will settle the airborne dust down. Trim and sleeve your negs right there in the bathroom. this has been a big help for me, and I do 16x20 prints with a condenser enlarger, so dust is the freaking enemy!

EDIT: Syringe and tube from Amazon (I'd trim the tube to a suitable length). This is for one-shot developers like Rodinal and HC-110, that you mix (just one dev tank's worth) before use. Why the graduate? Because a syringe is kind of hard for accuracy to the ML - do you add the cone-shaped end? But that's like another ML or 2... or 3? Just use the syringe to get the syrup from the bottle.

Yeah kid, i been there : ) Getting set up with volumetric dosing has been super useful. I put a 100 ug tab of LSD into 100 ml of distilled water, in a light proof air tight container in my fridge. I swirled it a little once or twice, and after 24 hrs I used a needle-less syringe to draw up 12 ml of the solution and swallowed the liquid. That's a 12 ug microdose, every time. Highly recommended.

https://www.amazon.com/gp/product/B00EPQ4PX8/ref=oh_aui_detailpage_o01_s01?ie=UTF8&psc=1

10 pack for 12 dollars

https://www.amazon.ca/Ajax-Scientific-Plastic-Luer-Syringe/dp/B00EPQ4QUU/ref=sr_1_16?s=industrial&ie=UTF8&qid=1499128527&sr=1-16

lots of cheap ones on amazon, shimano ships a 35mm but that pack will work fine,