Best metalworking ball nose spring plungers according to redditors
We found 2 Reddit comments discussing the best metalworking ball nose spring plungers. We ranked the 1 resulting product by number of redditors who mentioned them. Here are the top 20.
They are wood screws that just hold the sheet metal in. I drilled them out with a #7 bit and tapped it 1/4-20 ad threaded these in. You need to use a low profile 1/4" nut driver to drive them in until they bottom out. Then drill out the sheet metal to be 1/16th so they pop in.
I think I may end up going with two of these. And having some sort of wire/pulley system. Any ideas?
http://www.amazon.com/717-10-Stainless-Lock-Out-Retractable-Plunger/dp/B00BTIFCLY/ref=sr_1_4?ie=UTF8&qid=1458267282&sr=8-4&keywords=locking+pin+spring