(Part 3) Best propane torches according to redditors
We found 146 Reddit comments discussing the best propane torches. We ranked the 43 resulting products by number of redditors who mentioned them. Here are the products ranked 41-60. You can also go back to the previous section.
The weed burner is probably your best bet for a big flame, if you need a smaller torch then use a torch that's for soldering, not welding. Bernzomatic makes a good selection of these, look at their heat-shrink torches or their other broad-flame torches. Those sound like exactly what you want. Even their plumbing torches would probably work. You can experiment with blocking some of the air holes if you want a flame with more red in it. Also, you want to use a cooler burning gas, like propane (instead of mapp or acetylene). If you need to hold the flame on aluminum for more than 30 seconds fill the flashlight with water.
For example;
https://www.amazon.com/BernzOmatic-361472-BZ4500HS-Shrink-Torch/dp/B00834RCLU
https://www.amazon.com/BernzoMatic-JT680-361473-Jumbo-Flame/dp/B00008ZA0D
I'm a fan the of "fatboy" tanks that are shorter and 16oz because if you use something like this the torch head tends to be at a level where you can just set the tank next to your bong and it'll heat the nail up.
I think it may be an early blow-torch nozzle. The small hole is the orifice, the gap is the air intake. The tube is the flame port.
http://www.amazon.com/Propane-Torch-Extra-Nozzle/dp/B000FV90N2